Switching

HiI have had 2 x Cisco 11503 Content Switches delivered and they have been configured and installed. It seems though, that whilst we telnet into each device via the management port, during the session, the management port freezes, stopping all traffi...

HiI am trying to create a port-channel between a cisco CGESM blade switch using 2 fibre spf modules, and a cisco 4507R WS-X4418-GB module.I am unable to get the port channel to go active when I use 2 ports on the same WS-X4418-GB (and I have tried se...

Hi, I'm using 2960G switch, when i connect FO single mode cable, it is not showing link LED though the other end is connected with device, could please advise what could be the problem?

Greeting,Is there a difference between the network command and redistribute connected in OSPF i just notice that when i use redistribute connected (to advertize all my connected networks without using the network command) i don`t have the loadbalanci...

Is any restrictions or constraints in PBR on 6500 with sup32? Could PBR capable to work with 500 mbit/s load?

Hi,I'm testing a multicqst application (server and client) and am experiencing very high CPU load on my 4948 due to the IP Input Process.I've read document ID 41160 related to this but don't have a solution yet.It's a very basic test scenario, with s...

Hi,In order to reduce the impact of ARP spoofing attacks, I would like implement DHCP snooping and dynamic Arp inspection feature features on our Cisco enterprise network.Test were conclusive for all devices connected directly to cisco switches.Howev...

Hi,I know that we an SVI can be 'up' with either an access or a trunk port allowing the related VLAN.Lets say on Switch 1 we have a routed port on a switch (subnet x.x.x.x), an SVI (subnet y.y.y.y/24) and two trunks connected to different switches (S...

I have a new 1841 router that I am trying to setup DHCP on. When I enter the option command string ie> option 130 ascii "MITEL IP PHONE" , I get an error saying "% Invalid input detected at '^' marker.", where the marker is just before the word IP. ...

gusy we have a starnge problem i hope someone can help me out with that we had 3640 router which was connected to 3750 swicth and a lan printer was connected to that swicth as there were only two users (as the whole office shifted) now we have upgard...

Dear All,I am facing a problem as shown below.The NW Rough Di. is shown in attached.All the Aps Wireless connectivity from AP connected using UTP has high latency ( > 500 ms ) and frequent discoonection. When I remove the global Network and than chec...