Switching

Has anyone had an issue with sporatic ports working and not working on code s72033-ipservicesk9-vz.122-33.SXH2a.bin? What is the most stable ip services code currently for the 6513 sup720? We tested the cables and they are good.

What could be the cause of this problem:EVENT ID = 0000A18ALERT ID = 000014ITIME = Tue 05-Aug-2008 05:26:34 MSDSTATUS = ActiveSEVERITY = CriticalMANAGED OBJECT ...

Hi there,I have a port on a Cat 6509 in mode trunk :Interface Gigabit1/1 switchport switchport mode trunk switchport trunk allowed vlan 10,20!Is it possible for me to rewrte theese tags (10,20) to 11 and 21, so that I can have vlan interface for each...

Here's a good one. I have a blade system using (2) 3020 blade switches, (2) 3750's in a stack at the core. 4-port LACP etherchannel/port-channel (Po8) between ea. 3020 and 3750 stack, with (2) ports in the master, (2) ports in the slave. LACP active ...

Hi all,Does Catos show how it was rebooted like power on , reload .. etc.Can i know the CATOS command.

Is there training for the Cisco Catalyst 6500 Virtual Switching System 1440?

Hi All,A very basic question.I know ospf dont generate a defualt route unless we specify the deault information originate command. I would like to know the reason behind such behaviour. Though I have a default route and redistribute static routes to ...

Dear all,we had given 120mb link to customer. A end we have GSR and at B end we had 7200 router--Both end Gig port. When we kept MTU=1700 at both end or default 1500 . customer was able to open indian web pagesWhen we changed MTU on transmission equi...

I need help on setting up routing for a single subnet.At the moment all traffic is routed via the etherchannel(po1) to the R2 Router via ospf. What i would like to do is route a single SVI on the 4506 to R1 instead of R2.Can i apply a route map on th...

All,I have two Catalyst 4948's and I have a L2 trunk between the two of them. Evey time I hook that trunk up one of my switches reboots and it won't stop rebooting until I disconnect the trunk. Has anyone seen this before?

Can anyone answer whether or not the tftpdnld command is on a roadmap for future releases of 3560/3750 switch rommon code? We have run into several circumstances where this seemingly simple command would have saved us numerous hours of waiting on a ...

I have a server farm setup of four 6500 switches. They are running RSTP. The spanning-tree is not currently optimized for some server VLANs and I am planning to configure RSTP Primary and Secondary. Considering that RSTP has fast convergence (2 sec ...

Is there an image for the 6500's with sup720 that supports PBR on Layer 3 LACP etherchannels?

What files do I need on a catalyst 6513 to get it to boot?Here is what is installed..NAME: "7", DESCR: "WS-SUP720-3B 2 ports Supervisor Engine 720 Rev. 4.4"PID: WS-SUP720-3B , VID: , SN: SAL0917A12CNAME: "msfc sub-module of 7", DESCR: "WS-SUP...