Switching

Hi geeks, I've got a trouble as to the DHCP running on ASA 5505. It is not picking any external IP from ADSL router. Upon iterative modification and testing, still no luck in accessing Internet. My set up is: Internet--> DSL router--> ASA 5505 Here i...

I am planning to upgrade my Sup1A/MFSC1 6500 series switches to Sup 720's running IOS. At one time, I had a document from TAC that showed me a list of Cat OS commands and the equivalent IOD commands. I can't seem to find it, nor can I find it on CC...

Hello,A Cisco ATA is connected on a port of a 3560 which is configured to belong toa voice Vlan and also runs 802.1x MAB (mac-auth-bypass).Is this configuration supported ?.-If the switchport is configured only as a voice vlan port all is ok-If the s...

Hello All,Pls kindly check the attached document, is a solution we want to give to a customer kindly look at it for us if it will work.Thank u

Hi,I'm transmitting frames between 2 electronic board via a 3560-E switch. Each board is made with FPGA and broadcom ethernet chip. Frames are raw ethernet. I observed transmission problems for switch to board communication. I did some experiences: ...

Hi folks,I am working on setting up VMPS on some switches. In the VMPS database configuration file, I know I can configure a "default vlan" through VMPS fallback. Is it possible to give the different ports the different default vlans? Such as config...

I have a 3560 switch connected to a 6506 switch using a port channel of 2 GB. Everything appears to be configured and working correctly, however, when I do a show interface on the po interface, it shows a very large number of input and output queue d...

What this command does under the interface vlan 159mls rp vtp-domain TEST mls rp ipmany 10xs

Hello,I am trying to get MSTP working between Foundry SuperX and Cisco Catalyst 3560 switch. I have configured the regions and vlan mappings the same on both switches, but for some reason Cisco shows dispute on " sh spann mstp int gi0/47 det"Can anyo...

Hello,I have attached a picture of the way it is plugged, and wonder why I see no port blocks on one of the 6500's, but three of the 4 ports on the other one are blocked?If I shut down interfaces on the 6500 that has blocked ports it does failover, b...

I have a layer 3 with the following static route.ip route 0.0.0.0 0.0.0.0 10.24.46.224It is connected to a wireless shot. I also have a T-1 connection that I would like to hook up. But how do I get a static route so if the main connection is not avai...

helloi have mac address in multiple vlan:10 001a.30da.3c00 DYNAMIC Gi0/220 001a.30da.3c00 DYNAMIC Gi0/230 001a.30da.3c00 DYNAMIC Gi0/240 001a.30da.3c00 DYNAMIC Gi0/250 001a.30da.3c00 DYNAMIC Gi0/260 00...

Hello Experts!i Have couples of question if you plz?1)how can i trace Specific mac-address in Network2)if u have this command:no mls flow ipv6 on ur DS and on client Machine(XP IPv6 enabled but not configured,now when u disconect the cable from the o...

Anyone know what this error mean and how can this be stopped?Dec 9 16:47:32.317: %PM-4-ERR_DISABLE: ekey error detected on Gi0/8, putting Gi0/8 in err-disable state