Switching

Hi,On 7609, we have redundant SUP 720 3B's. Please help me in getting the commands that allows or disables Enable access to the Standby SUP.ThanksSumanth

Ping sample:Reply from 10.36.80.12: bytes=32 time=1672ms TTL=253I'd like to know what is the possible reason when im conducting ping to the ip indicated above im geting high value of time(ms). Note: It's an IP address of a switch in Vlan 80.

Hi all, I have enabled tacacs-server on cisco router and accounting is configured, but we noticed configuration done on interface mode is not logged while configuration on privilege/config modes are being recorded perfectly.The configuration on cisco...

I have a customer who has an existing 6503 in place, and they are interested in turning on Netflow. I do not believe they are licensed to run it. Here is a show versions if that helps any:echnical Support: http://www.cisco.com/techsupportCopyright (c...

Dearcan you tell me what is the difference with following commanderase startup configerase nvrami run "erase startup config" after my 3750 giving errorflashfs[0]: 0 orphaned files, 0 orphaned directoriesflashfs[0]: Total bytes: 15998976flashfs[0]: By...

Hi,I need continuous output (Not Page by Page with --- More --- prompt)for "Show interface" command from Cisco 4507 switch, so that it could be passed to a script for calculating incremental CRC, Collisions etc.I use "Terminal length 0" command befor...

I come form the days when a switch was a switch and routers were glad of it - to miss quote. So what's the difference?We want to connect 2 subnets with some access control between them. I presume that I could use either a L3 switch or a router with A...

Some newbie questions here. I've RTFMed and searched and read FAQs and docs, but ultimately could not ascertain 100% which models I should get and hope someone will be able to help me.My needs are quite specific:1. LAN -> LAN routing (two Ethernet po...

Hi all,We have a WS-C6509-E that we want to deploy. We figured out where to place the WS-SUP32-GE3B - in slot 5. We have 3 WS-X6148A-GE-45AF 48 Port 10/100/1000 IEEE 802.3AF switches. Currently, they are in slots 1-3. We would like to know about ...

My 3750g switch stack is reporting 45 degrees. It is a stack of 8 switches. Is this normal temperature? It says that 65 is critical and thats not that far away.What can be causing this to be so high, cpu proc is 8% constant.

I'm new to Cisco routers and I'm not too sure I understand how the backup connection works. I have a basic configuration with an ADSL connection to my ISP and one VPN to my head office. I have been trying to implement the async (modem) backup on the ...

Hey all,I have a router here which states that the clearing of counters is "never". I cleared them last week, why would it show this value? The only things that we're done on the router since then we're a couple of static routes, a copy of the runni...

so I've gotSpanning-Tree onPortfast enabled ONLY on ports that dont have switches or hubs attached to themQuestion is, should I disable or enable flooding control? Which would benefit the network more?also, what is the command both for IOS and CATOS...