Switching

COULD ANYONE TELL ME WHATS WRONG WITH THIS HSRP CONFIGURATION?THANKS.NOTE:interface GigabitEthernet1/1 OF CORE SW 1&2 connected to edge switch 1interface GigabitEthernet1/2 OF CORE SW 1&2 connected to edge switch 2VLAN 100 IS THE MANAGEMENT VLANCORE ...

Hi NetPro,currently my port-channel config at Cat6509 as below.Interface Port-Channel9switchportswitchport access vlan 64and used at Cat4507interface GigabitEthernet4/29description Ciscoswitchport access vlan 64spanning-tree portfastchannel-group 9 m...

First Question:I have heard that you can also transfer files, and upgrade the IOS for a network device (a catalyst 3550 for my case)using a console cable. I know that there's the common tftp tranfer method, but I'd like to know how do I go about usin...

I am finding conflicting info among cisco documentation for the acceptable threshold of collisions on a ethernet segment. A CCDA question was that the Cisco standard for collisions was .1% of total throughput. Divide collisions by packet output to ...

I am deploying a 5505 in a hosting environment. The following is the configuration.WS-X5530WS-X5302WS-X5224WS-X5224WS-X5225RWe will have about 70 servers in the next year most will be in 2 VLANs. 1 VLAN will have about 75% of the servers. I have 2 of...

what is the best practice design of having a redundant core switch?the scenario is;2 x 65002 edge switches in each floorthanks.

I would like to ask what is the cause when the LED of the swicthes blinking to fast.....

Hi everyone,I have been researching MPLS for a few days now with the intention of setting up a network to test MPLS operations using 2651xm routers and 2950 switches.Presently Iam simply gathering general information before I start the project.If any...

Hi!on 4507r,2 sup:sup-wsx4515;i need to configure the RPR Mode;do i need to put the console into sup on slot 2 and configure the redandany mode(rpr) or it is done in the 1st sup on the slot 1 if all config its done form there.10xs

Dear sir,My customer is having 2 isps one is from B.T(british telecom)&Primushe wants to terminate these 2 isps in one router and he wants isp failover.and primus he was having 2mbps out of this 2mb he want to segrigate 1 mbfor data and 1 mb for voic...

hello i have problem with our CORE SWITCH 4006 we reset to factory default, and it was now not running the IOS..what should i do?

Would a Catalyst 4506 chassis with Supervisor II Plus with IP Base be enough for core switch for this network or should I choose the Supervisor V or upgrade to a 6504-E?The network will consist of two core switches, each with redundant paths to 10 di...