Switching

How can i route between ip and ipx network in 6500 switch ?

Hi Folks, I need to replace a dozen SUP1A's running CatOs with WS-X6K-S2-PFC2's and copy the configs over.I don't think I can just put a Sup2 into slot 2 and have the configs sync with the active Sup 1A in slot 1 because the hardware is different, ri...

If i have vlans 2,4,6 with priority 8192 via CS_1 going out of this core switch over a les link to the datacenter and vlans 3,5,7 with priority 8192 via CS_2 going out of this core switch over the second les link. when traffic returns back to lets sa...

Exisitng EIGRP networks config'd on *REMOTE* router but need to add other networks to EIGRP w/out locking myself out.As this is prod router, an outage cannot occur. Here are steps which is the long way of doing it:1. remove ALL distribute-lists fro...

Hello, We are facing a routing problem, that when we trace route to the same Destination, different routes appear every time when we trace the same destination. and also facing Uploading and MSN messanger loging problem, because of this...

I have cisco 2600 router which already has 512 MB leased line connectivity. I would like to add an additional adsl line. can any one suggest me the possibility?Thanks

i have IDS sensor connected to port 6/4 on the BB swich (4507)and i want the sensor to monitor all the ports on the BB. I found that i must determine the source span ports and destination span port and configure the monitor session command on the BB....

Hi all, I know cisco dont do this yet, but I believe that its a feature of nortel, I have seen I diagram where they have an access switch connected to 2 distribution switches via smlt, this is where the access switch has the 2 connections binded to f...

I notice my 2924 swith fa0/1 and fa02 get input error. Received 476 broadcasts, 2091 runts, 0 giants, 0 throttles 2091 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored Received 475 broadcasts, 225 runts, 0 giants, 0 throttles 225 in...

Hi,I want to connect a router (7206VXR, NPE-G2, 12.4(11)T1) to 2 switches (6509, 12.2(18)SXF) at layer 2. The configuration I'm trying is:router:!bridge irb!interface GigabitEthernet0/1 description - connection to switch2 gi5/2 - no ip address duplex...

I have Cisco 4507 box with two redundent sup's, I am plannibg to buy another new 4507 box and move one sup from the old box to the new one, do I have to purchase new IOS for the new box or I can use the same IOS which is on the old 4507 box?Thanks.

I am getting the following error when trying to boot catalyst 6500 with a WS-SUP720-3B. Any information on how to fix this will be appreciated. 00:00:52: %C6K_PLATFORM-SP-4-BADFLASH: Unsupported flash type in the bootflash - Setting to READONLY. Will...

What are the differences in the SUP720 and SUP32 for the 6500 series, to be used in a LAN Core? I know that the SUP720 is more "powerful", where or why would I use a SUP32 ?ThanksDJE