Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a static Route Based VPN and am wondering if I create a loopback interface on the FTD is there a way to allow this IP over the VPN to test the VPN or generate some traffic from the FTD across the VPN ?? Thanks
Hi, i'm looking into buying a Cisco Catalyst 1200 switch and the product page says:"With Cisco Catalyst 1200 and 1300/X Series switches, there is no license to purchase, and software updates are available at no additional cost. The switches offer a l...
Trying to get into the C1111-4P router after powering on it can't find the IOS image and also I cannot get into ROMMON mode can you help please thank you:Rom image verified correctlySystem Bootstrap, Version 16.9(1r), RELEASE SOFTWARECopyright (c) 19...
Hello everyone,I have a problem with my IW9167E access point running the WGB software. The AP is connected to a switchport configured as trunk, and behind the switch I have 2 VLANs:1x VLAN for management1x VLAN for trafficThe AP and the switch both h...
We have Cisco FTD 2110s that are managed with FMC and we are trying to figure out how to block access to our remote access VPN by IP. We already have a geolocation block for Access Control in FMC. But, are we still not able to do geo-ip-based restric...
Hi everyone,I’m having an issue with Cisco Unified Communications Manager. Suddenly, adding or modifying any IP phone has become a problem—especially the 8865 (and several other models are affected as well).I’m currently running CUCM System version: ...
I currently have an FTD that has public DNS configured on the management interface (>show network, >show DNS system have Umbrella IPs). I have internal DNS IPs assigned to inside data interface using the platform policy. I did not check enable DNS...
I have a customer with a 4400 series ISR CUBE & no SmartNet coverage. The SIP connection is cloud based through a firewall & the Ip addresses are getting changed by NAT to an outside IP address. The carrier is requiring the internal Ip address not b...
Trying to lab a few scenarios with a 9800 WLC vm, wondering if anyone can confirm if we add two or three 9166CW-B AP (wifi 6e) to the lab if Cisco will require a license? anyone try this?
What precautions should we take when we transit legacy network to SDWAN network ? how can we do it in minimal downtime ?how can we replace devices in minimal downtime in LAN network /DC network /WAN network ? precautions
Hi I struggle with an EEM applet or policy that should reload a router in case a condition matches. The trouble is that the reload command ask for confirmation and EEM does not seem or want to understand that concept. I asked AI but all suggestions s...
Good morning Cisco Community, I feel like i am over looking something simple here. I've built a SVI and propogated it into OSPF on a L3 device. On one interface of that device there is a host connected through two cascaded layer two acces switches....
Hi Everybody I have an old cisco 7200 router. Unfortunately the cf card missing. Sup card type NPE-G2 v03. I have put a128MB cisco cf card from an other route. Before that I copied c7200p-...bin IOS to the cf card. When I start the device the prompt ...
Hello,I need to renew a certificate that is expiring soon, which is used for Admin access, EAP authentication, and RADIUS DTLS.This certificate is signed by our internal certification authority.I generate a CSR and sign it with our certification auth...
