TelePresence and Video Infrastructure

Can you let me know if you can have a mixed mode Video conference i.e H323, SIP and SCCP. I know you can dial into a MCU using a "Meet Me" set up but can a H323, SIP device conference, set up a conference in a SCCP end point and vice versa. A call st...

Hi, allI have found the following dial-peer in several case stadies. It match all called number, but there is not voice port configuration under it. So what is the effort for this dialpeer?---------------------!dial-peer voice 10 pots incoming called...

Would it be possible to display the IP address of an incoming caller on my caller ID?The calls are from 7931s at remote locations to another 7931 on my desk.

Can someone confirm whether or not Meetingplace Express when combined with a MCU (specifically the 3515 MCU-12 5.5) WILL provide multiple video layout (Continuous Presence).I vaguely recall seeing a simular setup with the stack video layout but there...

I have Snom phones utilizing an Asterisk server. Sniffer captures are showing what I expect and ports 10686 as the dest port from the phone. However RTP packets sent right back from the Asterisk server are destined for port 50488.Does this mean I nee...

Hi,I have a DMM 4.1, Digital Media Encoder 1000 and Cisco digital media player 4305g.I get to the point where I need to configure the values for the Video Portal module (http://<DMM_IP_address>:8080/DMM/) and its asks for the instance name which i do...

I need to configure a call, in an UC500, between two IP comunicator with cisco Video advantage .Voice calls between both IP communicators are Ok , but video advantage shows the same image in local and remote window. I seems like the ip comm or the UC...

Dear all, I am using CCM5.1. I am generating the Call Report daily through CDR Management.But Last two days I could not generate the Call Report. Bcz. When I am going to generate the report..It s showing a Meesage Like Below" Data is not available fo...

We are experiencing intermittent dropped calls on 3 phones; (2) 7942s and (1) 7962. The drop calls happen between IP-phone-to-IP-phone and IP-phone-to-voice-gateway. The network consists of 5 Catalyst 4510's, 1 stacked 3750; 1 3845 (voice gateway); a...

Hello,1) I have Snom phones that show them using DSCP CS 5 (0x28) on captures.2) Asterisk servers showing DSCP AF31-low (0x1a)I have the following configuration for my Cisco 2560 switches;#Access-list with Snom SIP & RTPip access-list extended voip-t...

HiWe have the below setup E1 QSIGAnalog Phone --> PABX --> Voice Gateway --> CUCM --> IP PhonesAre are able to place calls between the PABX phones and the IP phones. However, we do not get any audio after the call is picked up.Hav...

- Can the Cisco 7985 phone (or other models) be used for VideoConferencing, or does it not support the required Codec's?- Can you all elaborate on the concrete distinctions between Video/Web Conferencing and TelePresence? So far, to me, it seems to b...

Hi, can anyone tell me what the new VG 202 or 204 gateways are?...do they have less ports than a VG-224 and VG-248 ?

I'd like to put together a small PSTN switch for lab purposes and am wondering if anyone has any experience or pointers. In my lab, I have three ISRs that I would like phones in each "branch" to be able to call any other branch T1 or E1 PRI. I don'...