TelePresence and Video Infrastructure

Hello,we have some trouble with one of our C40 Codec. Since we upgrade the codec with a Template, the codec is booting in a loop.Connecting to the codec serial port I get the following message:U-Boot 2010.06-101 (May 23 2012 - 13:26:22) MPC83XXReset ...

Hello, We have a demo DX80. Does it support auto-registration on CUCM?But even when I try to register it manually, the number gets, but the calls do not pass.Other phones are registered normally.

With my own SX80 on-site at my corporate headquarters, I'm using NEC Professional 80"displays.  As a result, if the image from a laptop doesn't look quite right, I can use display settings to auto-adjust the image, turn overscan on or off, etc.But in...

Hi, I was using  a device  from vendor x for video conferencing ,it supports only h323 call..Where we use ip address to dial-in and dial out . Now I am planning to use cisco expressway with sx end points and meeting servers . Now my doubt still I can...

Hello,   Is there a way to configure TMS(with Analytics Extension), or VCS, to push endpoint usage data to Splunk?   Thanks  

Hi,   I am working on designing project with CTS-SX80-K9 which will be controlled with Crestron Touch Screen.   My question: can we order only the SX80 codec (CTS-SX80-K9) without ordering the  CTS-CTRL-DV10.   Appetite early support.   Regards,   Im...

Hello,   Can anyone explain the mechanism/difference behind endpoint registration on VCSc cluster FQDN, on ports 5060/5061? e.g. We have 2 endpoints located in the same network(DNS SRV records are the same), running the same software version, having ...

When I power on my EX90 I get an orange blinking LED light on the top left of the unit. I do get a large "Cisco" symbol on the screen, but that's it. Can someone please tell me what the orange blinking LED light means?

How would I go about reloading an SX10 with a failed OS, are there any instructions anywhere?

Hi,   I'm having a play around with the "System Upgrade" capability in TMS with a view to using it to perform some endpoint firmware updates. I scheduled a software update event for a time when I knew the target endpoint would be off, to see what wou...

Let me start by saying I'm new to VTC in every way, but somehow I was lucky enough to have this system land in my lap.  I've learned quite a bit about it, and have most of my configurations under control.  Currently I have about 25 endpoints (EX90, S...

I have CISCO 8865 VDO phone and other model of cisco ip phone as well and want to connect with my TMS its version is 15 , is it possible to connect these VDO phone to my TMS ??? and what is the procedure to connect with my TMS ??? further how to book...