When uploading the 4.4 image file to my 4501 MCU I am receiving image validation failed. I've tried useing Firefox and IE9. Please adivse what can be causing this error.thanks
Hi,I have a Cisco Sx20 Device along with MS feature, In this i have installed Cisco Jabberclient in my IPAD2 integerate with CUCM8.6.My query is if i am dialing a point to point, from Sx20 to Ipad2, it was working fine. If i am trying to establish a...
Hi All,I would like to know if there is any chance of deactivating the manual calls of the Endpoints. The aim behind this idea is to force the users to schedule the meetings because we are finding lots of problems when they try to manipulate the endp...
Hi All,A simple query. With Cisco ios NBAR, when we say 'match protocol rtp video' , do we also match the audio embedded in the video stream ? .. or does that audio get matched only with the 'match protocol rtp audio' statement ?Also, is the 'match p...
Hi all,I'm installing 6000MXP, Tandberg Video Switch and two PrecisionHD Camera as this diagramNow I can switch between two cameras. But there's a problem as follows: two cameras can't be controlled via remote control. I don't know why's that.I wonde...
Hello,I'm trying to achieve something very simple: Join an audio call into an existing Telepresence session.Our Telepresence CUCM are in 8.0CTS is 1.7Our VoIP CUCM are in 8.6.2aI have setup a SIP trunk between the TP and VoIP CUCMs and setup all the ...
Hello ,In terms of latency, would we see a higher latency with units coming from overseas? What should we expect, and therefore set our thresholds to?Thank you
Is there any reason the filmstrip would not show up on a 3010 unit while it was in a conference on the 8710 blade with other 1300 and interop devices. Everyone else saw the filmstrip except for the 3010. Is this normal? I was under the impression tha...
Wondering what Cisco and or anyone that uses any type of MSE 8000 based hardware thinks of the ability to utilize AD or domain accounts for login instead of the current manual creation/maintain method currently in use?
Dear allIs it possible to make license transfer of VCS-Control as appliance to a VMware ? also convert the whole running VCS to a VMware.If yes, what is the procedure and amybe exist a Purchase Order ?Best regards Georg
Hi,As per Cisco document document cisco Jabber client suppose to use media port 50000 to 52399 or 21000 to 21900 and i have opened the same port in my firewall. but i can see in my firewall internet jabber endpoint is using port 53xxx range to commun...
Hi all,I have a problem with a new TMS phonebook setup and have hit a small stubling block which I can't quite figure out:Client wanted an AD phonebook to facilitate VCS to CUCM dialing. CUCM is importing accounts from AD and with the extention bein...
Dear all,WIth refer to releas note X7-2 page 17, Resolved caveatsCSCtx15355Symptom: When receiving a H.323 Setup message and interworking it on the Cisco VCS, the SIP INVITE may go out with Contact and From headers of iwf@VCS_IP_Address if there is n...
