Hey UCS Community,We have a problem opening the KVM console on a UCS Manager in a remote site. There is a firewall between the sites.What ports need to be allowed for the KVM console to open? Thanks!Mike
Hi there guys.The plan is migrate the uplinks from a fews 6500 to a couple Nexus 7000 using pingroups with no trafic disruption. So i have made a desing but i not sure if this is the best way to accomplish the objective without problems.This is the d...
Hi, since a few days I had UCSM Gui show up this way: as you can see, no picture of the ucs chassi are shown.I was used to see this from time to time buy now its seem permanant. (usualy reload get rid of this issue)I tryed reinstalling Ja...
Under the status tab in UCS Central it saysDiscription: Configuring Service Profile SP-Demo-Blade1(FSM:sam:dme:LsServerConfigure)Status: ConfigureResolveIdentifiersStage discriptor: Resolving identifiers from UCS Central(FSM-STAGE:sam:dme:LsServerCon...
Hi I'm in the process of setting up a HyperV iSCSI boot environment which consists of the following components:FI6248UP5108/2208XP FAS2240/ONTAP 8.1.3B200M3/VIC1240/PortExpanderI was wondering if someone could shed some light on the actual Windows i...
Hello Experts,I need your assitance to undetand the design / Connecitivity for below Hardware together:2 UCS Blade Servers UCS 5108 Blade2 Fabric Interconnects: FI 62482 Nexus 5548-UP2 Nexus 2248I need to know the design strategy for above devices. P...
Hi All!In the UCS Cetral we've applied the Dynamic vNIC connection policy to the whole Service Profile. After that 54 dynamic vNICs were created, respectively. But they were created without any MAC addresses. It causes the error while associating SP ...
Hello,I have two UCS C220 M3 Server integrated in UCS Manager, and I need to install Windowss 2008 R2 Enterprise 64-bit, but I have a problem with the HDDS, the following error occurs when installing:(Re-map the iso w2k8)"Windows cannot be installed ...
Hi experts!I have a question around vNIC failover and LAN pinning.1) I understand what when you enable failover on a vNIC say on FI A, it creates a Standby/Passive VIF/circuit on FI B. In doing so, I guess you will have to manually LB the vNIC's acc...
Hello,I am planning to upgrade a vCentre instance to 5.5 , prior to that I need to find out what versions of VM-FEX / VIBs will work with it. I have been looking for a while and can't find a compatibility matrix, does anyone know where I could find i...
Hi,Is standard access-list allowed on the Nexus 5548? If it is allowed, can you please advice how do you do that?Also, when upgrading a Nexus 5548, do we upgrade the kickstart first then system nx-os?TIAPF
Hi Guys, I have received a new blade and installed it into the chassis. Now, it's time to give it access to the SAN. This is new blade is the 7th spread in two chassis... Accurently zoning is done in a N5K switches.... Below is the c...
Hi Experts.I have three UCS C220 servers, out of three one server dedicated management ethernet port is giving very strange behaviour. It is working with one or two Cisco switches and not working working with any other switch, even with the laptop, i...
