Unified Computing System Discussions

Hello Folks,I'm using the SW Raid feature of an C200 M2 Server. It works well, but if the server is disconnected from power for some hours it "forgets" the SW RAID Setting and boot order in the BIOS, defaults back to Enhanced mode. BIOS and CIMC Firm...

hi hope yo are okay , long time not to get back here I have two question about the UCS BLADES B200 BLASED, I am using the 1.4 UCS release 1- did I need to assign an customer LAN (external IPv 4) for each Blades to be accessed through KVM withen the U...

Hi, there everyone.I'm curious if anyone can add a little value to a couple of questions i've got while doing a current implementation of UCS.  Both of these issues really are layer three issues that should be handled by a layer three switch upstream...

I have setup UCSM but the SAN switches (EMC) could only see all the WWPN on each server's vHBA, not the WWNN. They are all UCS B200M2 model. I saw the WWNNs are already assign to all service profile as shown in the storage tab. Has anyone encountered...

Hi,i would like two know what the best practices are regaring keeping profiles on multiple UCS environments in sync? I have two rooms in a DC and in each room there is a UCS system. I would like to keep the nic templates/hba templates/service profile...

Environment:One chassis, 6 blades, B200-M2Two Fabric interconnects, 6120XPOld firmware: 1.3.1nNew firmware: 1.4.3sProblem:When we activate UCS Manager from 1.3 to 1.4, we encountered all the 6 blades reboot suddenly and this does not match what the d...

Is it possible to connect a 2248 downstream from a 6120 and have it act as a fex or is that not supported?

I'm a newbie to UCS C series, customer has C-200 series servers. All are working fine customer just called and mentioned there was an Amber light in one of the servers. I checked the CIMC log here is the Waring and Critical error shown in the log CRI...

Hello everyone!I have this network configuration:6500 connected with 6120XP using a trunk port with all VLANs and VLAN 1 set as the native VLAN.In the UCS LAN Cloud are these VLANs:VLAN abc (400)VLAN cde (401)VLAN default (1) with native=yesVLAN 1 is...

Hello all,I have a problem with vnic/vhba placement policies on an UCS-B:When a configure a Service Profile, evrything is good:- I use a "specify manualy" vnic/vhba placement policy  and can create this configuration:- vhba 0 : Order 1- vhba 1 : Orde...

Pardon the picture, I don't always have access to visio. We have a home office and DR site connected via two 10Gb links. Those are port channeled on VSS pairs on each side. We are trying to connect fibre channel - or FCoE - between the two sites, whi...

Hi,Before deeping dive into the installation process of Nexus 1000v, I was wondering to what extend the vCenter Server all-in-one appliance (vCSA) was supported.It seems the vCSA has some limitations (e.g. no support for the Update Manager), which mi...