Unified Computing System Discussions

Hi, I have to swap out a chassis with a new chassis, i have a couple of questions: the old chassis had power issues, so we have been sent a new chassis.  1: Is it easier to use the original ioms (so they are upgraded already to the same firmware)?2: ...

Hi,I recently had a strange issue come up.  We recently added some b200-m4 blades and put ESX on them.  We also have some M3 blades in the same ESX cluster as we are migrating off.  We needed to add a new vLAN to these blades, which is common.  I wen...

Hi,We will be using the HUU tool to upgrade our UCS devices firmware and BIOS, since these are VM's are there any steps that needs to be done on the ESXI host or the VM's before the upgrade.  Any assistance would be greatly appreciated. Thanks, 

Hi,We have a UCS model BE7M-M5-K9 that the CIMC restarts periodically,  I looked at the device system event logs and found these entries BMC_OOM_RESET: Watchdog sensor, Hard reset and BMC_WATCHDOG: Watchdog sensor, Hard reset errors. I did find a bug...

How do I shutdown a B200 blade server in UCS Manager 4.1(1b) with no Service Profile?The GUI commands Boot Server & Shutdown Server are greyed out.Do I have to associate a temporary Service Profile, shutdown the server, then un-associate the Service ...

I have to do a Proof of Concept (POC) with Snowflake and I am new to Snowflake and looking for advice.Use cases:Have to load data for 7 tables (5 dimension tables and 2 fact tables) from Microsoft Dynamics AX (On Premise) to snowflakeTwo tables are b...

Hello. I currently have a 6332 domain and I have it set to 4 links.  I want to bring it down to 2 links to fit more chassis (do not want to buy licenses)  and really did not need it to be 4.  If I change the links in the GUI to 2 from 4 would I need ...

I have this issue on both FIs after an upgrade.  I am going to run the command connect local-mgmt (a|b)(local-mgmt)# reboot e2fsck I will do this on the subordinate first.   Question:  Is it wise to first evacuate via the GUI before running this comm...

I have a Cisco UCS B200 M4 blade in a Cisco UCS 5108 AC2 Chassis connected to 2x FIs. The server was used with ISCSI boot and for some reason a decision was made to use local boot for all our servers, so this blade was decommissioned for later use.I'...

Hello, UCS c240 rackmount server, CIMC upgrade failed & I've tried resetting CIMC to factory defaults by pressing F8( I see entering CIMC configuration utility) but it would redirect to Aptio utility. I tried power cycle and it didn't work out. I dec...