Unified Computing System Discussions

Hi:Just want to know the difference of the following 2 configurations for SAN Boot for UCS with 2 WWPNs being presented from SAN Storage Array: I know 1 will work, but how about Option 2????Cisco UCS manual DOES NOT go into the details needed.1.SAN P...

Hi,Currently we are running the folllowing configuration2 x Chassis2 x FI8 x Blade Servers (4/Chassis)2 x Server ports per every IOM1 x Ethernet Uplink port per FI1 x FC Uplink port per FI.In the future we are looking at increasing the amount of Blad...

Has anyone configured a connection to an EMC SAN from the Cisco Fabric Interconnect via 10gb ISCSI?  I know that you have to configure the port as an "Appliance Port" for connectivity, but I'm not able to get traffic to past.  Any ideas or documentat...

We have a UCS 250 M1 server and last night we had a power failure.  The system did not automatically restart after the power was restrored.  I have looked through the BIOS and the Managment counsol but I could not find any setting that would cause th...

Is there any way to turn off some of the UCS fans in an appropriately cooled room to reduce the overall noise levels?Also, does UCS have any management to show the speed of the fans or does it allow one to manually adjust the fan speeds?Thanks

Hello,I am attempting to install Windows 2008 R2 from an iso downloaded directly from Microsoft on ESXi 4.0 update 2.  The server is a C210-M2.  The iso is booting to the initial install screen properly, but when electing to install I am immediately ...

Greetings all,Please note that the second maintenance release for UCS 1.4 is now available for download from Cisco.com. This release, 1.4(3i), is a bug fix and stability release. It also introduces support for the new B230 M2 and B440 M2 platforms.As...

Hi,     Is it possible to move a configured UC vm from one C Series server to another without using UCS Manager?thanksColin

Hi,Do the  megaRaid LSI card can simultaneously manage two types of RAID in a server? (eg. RAID 0 and RAID 1). Regards

Hi All,Has anyone come across an issue with firmware version 1.4(2b) where when trying to disassociate a profile from a blade, it fails & errors out. The overall status is then stuck in config mode.i have attached a screenshot of the FSM. I have alre...

Forgive my ignorance, but this is my first experience with the Cisco line of servers.We have a Cisco 210 rack server that is currently in a stand-alone configuration.  I am running into some confusion concerning the embedded NICs that come with the s...