Overall Objective:Need to make physical nic on rackmount Cisco UCSC -C220-M5SX available and assign to VM (Windows Server 2019) residing on a Cisco USCB-B200-M5 that exists in a Cisco Chassis that is connected through a Fabric Interconnect. Cisco UC...
upon receiving power, it does in standby for a bit, before the blade health LED flashes green, and then the power button turns green, and it says that it is testing memory, before going back to standby, with a solid amber blade health LED. The RAM is...
Hello all,Maybe this question was published before but i was unable to find an answer that solvedy issue.I acquired an UCS C240 M4 recently with firmware version 2.0.I upgraded to version 4.2 without problem.Since I had no access to the CIMP web int...
Hello Bros'I have a question regarding Cisco UCS system with specs as mentioned below:UCS manager 3.1(3b)Chassis 5108Ucs FI 6248upIO module 2208xpDue to creticality I wanted to consult you regarding changing the IP addressing used in the management a...
Ive a pair of new UCS-FI-6536s and they are all set up and working fine in IMM but we cannot SSH to them as we did on the old FIs.They are on the same VLAN as the old FIs and there are no firewalls inbetween them.Does anyone know if this is even poss...
Hello Bros, Today I have Found this IOM error. on both IOMs. "screenshot attached".UCS manager 3.1(3b)Chassis 5108Ucs FI 6248upIO module 2208xpNo changes at all have been done recently.Any ideas how to respond to this failure.TIA.
Default vsan (vsan0001) in UCSM is showing as Admin status okay but Operational status down (major alarm from Monintoring system)=========================================================================================================================...
For anyone having issues configuring UEFI boot parameters when configuring boot-from-SAN, I believe I have figured out a CLI solution, which is much better than the workaround mentioned in the bug report:CSCvt79874 - Cannot set UEFI parameters for SA...
We have CIMC reporting to our Tenable scanner that it is vulnerablity to Terrapin Vulnerability. see below : ./Terrapin-Scanner Report Remote Banner: SSH-2.0-OpenSSH_8.8 PKIX[13.2.3] ChaCha20-Poly1305 support: trueCBC-EtM support: fals...
Hello , I have a Hyperflex cluster which consists of three nodes, and we made a physical migration from place to another place , and I stoped the cluster and put the cluster esxi hosts on maintenance mode, and after relocating the cluster and powere...
We using HXDP 3.0 version, and when I check the status of the HX cluster, it shows that the status is normal. However, in the HX cluster service check section, it fails with the message 'Internal service call failed. Please check configuration.' It s...
Hello I am kwon. FI 6248 has been determined to be RMA and is scheduled for replacement. However, the existing FI is using UCS-FI-E16UP. If I install this with RMA FI, will the 8 port license of UCS-FI-E16UP be activated?
Hi Technical Support Tea, The Cisco C220 M3BE Hardware Server keeps restarting even though the power supply is working. What could be the root cause. Regards CHUMA
We have a vnic template that was originally setup as a Initial Template by mistake, can this be changed to an updating template without issue? We are also in the process of planning to migrate from a L2 disjointed deployment to a single VTP domain. ...
Hi guys,We have a UCS220 which seems to keep randomly restarting on us. We only have 1 PSU attached at the minute, but is connected to a UPS and no other devices connected to the UPS are having any problems.The last restart happened today at about 3p...
