Voice Systems and Accessories - Small Business

Hi,Has anybody found the firmware for this phone? I've been shipped some on 7.4.4, and I can't even find the bin for that version online. I've had a few hangs on the phone so I was hoping to upgrade, or at least re-flash with the current version. I c...

good morning all, i recently installed a UC560 for a client on a local site using Cisco Configuration Assistant. Version: 3.2 (2) system details:UC560running latest revision 8.6.1all inbound/outbound calls via siptrunk system is all working as desire...

I need to configure a restriction on the Outgoing Calls, i need the extension that start whit 1 (100,101,102,etc..) to only use the FXO ports 0/1/0  0/1/1  0/1/2 and the extensiones that start whit 2 (200,201,202,etc...) to only use the FXO ports 0/2...

Hello sir, how are you?Look, I am very newbie in the uc560 and IDK how can I make this.My boss want I make a line, as 9980, to all people call and make a conference call. I dont need password and cant put limit of people.How can I do this over termin...

                   I would like to know the options to add a SPA500S addon to the SPA514G phone. I am running these phones off a DMS500 CS2K switch.

I will start from the beginning... A call comes in on one of four FXO lines and the auto attendant answers.  There are two options.  If the user hits #1, they are forwarded to a Call Blast Group (ext 511) that several users can answer.  If the caller...

Hello,     I saw another person post this question but went unanswered.  Is there any way to make a SPA 50x ignore a multicast page while the phone is on DND ?  I have tested this with an SPA 525g and this is how it functions already but on any of my...

I have a SIP trunk (no FXO ports) setup through flowroute with a separate DID for my fax.  I have entered my fax DID as a specifed number in the UC320w to route to the FXS port, but it rings through to the same hunt group as all my other incoming cal...

I am using the SPA 504's and 303g phones in an asterisk / FreePBX environment.  For some reason if a user is on the phone and another call comes in, the phone does not ring.  I enabled all three line keys on the 303's as Ext1, and all 4 on the 504's....

Hi,I have an SPA8000 Bridged to a ADSL2+ Modem and the SPA8000 performs PPPoE Authentication. If there is a drop in the service, it will automatically redial back in, however if there is an extended outage (eg. Loss of Line Sync, Carrier Issues) the ...

Ok so i have to offices that i want to interconnect with the Uc320w  and UC540, the main one has the UC540, i want to make extension calls  between the two, in the two i have an equipment that provide dhcp to  data lan and the UC's provide the dhcp t...

We are working with a client training them on the UC560 and SPA508G phones.  Is is possible for the phones to signify what exact hunt or blast group is actively ringing their phone?  They have several phones that are going to be a part of 3 different...