Voice Systems and Accessories - Small Business

I need to reload the CUE module in our UC520.  We can't access it right now, just get the waiting.... message for a long time.Is service-m i0/0 reset  the right command to reload it without losing any data?  I cannot reload the whole router.Thanks

I am trying to reset my UC560 to factory defaults becuase it looks like my VLAN.DAT got corrupted.  I tried deleting the vlan.dat and adding the vlans back manually but that isn't working.  sho vlans reveals "No Virtual Lans configured", however show...

Last week, my SPA112 was suddenly unable to receive incoming calls. The LAN traffic light was flashing continuously and SIP stats were showing over 1 GB data received per day.My VOIP provider, CallCentric, ran through several troubleshooting steps ov...

For several months I've been looking for how to configure the Uc540 to accept iphones and how to configure the CISCOMOBILE App 8.1 (or the new Jabber) to connect to the uc540.Before, some people write that its not supported yet, but yesterday I noted...

hi,i need to configure a fax machine with my UC560, we have SIP trunk for incoming and outgoing calls--> Fax from costumer --> Sip Provider --> UC560 --> FXS Port --> Analog Fax Machine --> how can i configure it

Hi,I need to prepare for a new phone system.  They will be using SPA504 phones and in order to prepare for the new system, I need to create a paper template for each phones with the position of the appearances and functions on each keys and softkeys....

Hi all, i was wondering, is there a restriction to get a 2 port ivr license     for a cue that is in a UC540?I guess not since it is a normal CUE module attached to an IOS based device.

i'm trying to setup an ipsec vpn tunnel between a rv042 and a uc540.I think I need to setup the VPU tunnel through CLI since CCA can only do EZVpn.can anyone give me an how to or something like that ? i'm newb at cisco CLI.thanks

We have installed a UC320W at a client's office and they have 5 SPA 540G's and 2 FXO lines - 1 regular and 1 Fax.  Question - is there a way to suppress the ringing of the fax line that is being used as a outbound only?ThanksBill Griffin

Hii've setup email notifications for new voicemail on my uc540 with my usual SMTP settings but it's not working.where can i go to check out the logs and localise the problem ?

When callers call they are answered by the auto-attendant(AA).  The AA plays a greeting such as " Thank you for calling...".  The callers here "...for calling...", the beginning gets clipped everytime.  If I call the AA internally, the problem does n...

HelloI have a doubt the port configuration between the UC and the Switch has to be mode access or mode trunk, because I have it mode access in the voice vlan and is working fine, but someone told me have to be mode trunk and I have that doubt.thanks

HelloIt is possible to do a link between UC540 and CUCM. Something like a dial-peer or a trunk???Best regards

I have a multi-site I am working on and we need a line appearance for the phones at the remote location at the owners desk. The owner has a 7965 phone and two 7916 and we want to put the 6 phones at the remote site on buttons on teh 7916 so they can ...