Voice Systems and Accessories - Small Business

Hi guys, how is it going? I would like to ask your help and present you a challenge:   In a CUCM 10.x environment, when my users call '8000' I need that: - 1st option: Calls are routed to other PBX system (a SIP gateway connected to CUCM); - 2nd opti...

I'm new to using the SPA8000 but have substantial experience with the SPA112 2-port ATA.  I am attempting to register and use each of L1 to L8 against our AVAYA Session Manger (ASM).  I have no problem in registering each line against our ASM with ea...

We have a UC560.  I  have an elderly person that continues to call our phone system all day long and doesn't realize they are calling the wrong place. I need to block their phone number because it is becoming a huge disruption.

How do i configure and see that my spa112 is using UDPTL over RTP?    

Hi, anyone can help with this issue?   We have had a problem with SPA112 this week. The subscriber complaint about scratchy sound from his ATA. Something like a bad cable or bad rj11 connector. The only way to fix it was to reboot the device.   It ru...

I would like to have a feature in my office where we can send a signal through the Intercom System on the phones, but instead of a live speaker with a person's voice paging someone like an overhead system, we'd like to use bells or tones to alert emp...

I have adjusted the levels in the ATA but it makes no difference.

Are there any plans to support telnet or SSH access to the SPA122s? In most cases when the GUI is dead (a constant issue in the buggy version 1.2.1-004), if CLI worked, maybe we could remotely reboot these things and save someone a trip to the custom...

Hello the community,   I'm using for many customers Cisco SPA509G with master and slave SIP server (asterisk).   This is working perfectly by registering the sip account on each phone server using this proxy parameter for redundancy (according to the...

Hi, I am trying to reconfigure 4 x 508G ip phones when i put in the ip address i only get to the device information page and cannot get in to the admin configuration?   any ideas!!!!!    

I have searched a while, looked in manuals, but, I still don't have a clear answer to what our phones are trying to tell us.   We have phones that reboot, each one of them, maybe once a day.  Not always all of them.  They could be in the middle of a ...

I am trying to putting a logo onto some SPA502G and SPA504G phone, I have the image at 128 X 48 pixels and a depth of 1 pixel (also tried saving in monochrome). Running a TFTP server off my laptop I can see the phone picks up the file but does not di...

Hi. Have a problem with Cisco spa504g. Can't transfer a call from outside. There is no button on diplay, but there is when caller is local.