Voice Systems and Accessories - Small Business

Greetings,I have a client with a SPA8000 latest firmware version having the following issues.This is a first time implementacion, and he is registering to his own PBX IWATSU.He also has a VPN tunnel from a remote location to where the PBX is at. When...

does anyone have documentation how this is usedit seems when doing this it is trying to login to the provsioning page given in Profile_Ruleif using no Digest auth, the EM says it's logged in and will reboot the phoneif turning on Digest auth, it seem...

Will the SPA932 be supported with the SPA525G phone on the UC520 in SCCP mode? The command for configuring the SPA525G with a SPA932 would be similar to the following when such feature is supported:ephone 1device-security-mode nonevideomac-address 00...

Hi Allat the moment i configuring 9000 box with Mediatrix 4402and hve difficulty with incoming calls , using step - by - step instruction but didnt recieve calls , software SPA 6.1.51. Outgoing calls fine2. when i make debug on gateway it show that l...

I enabled call accounting on a UC520-48U-T/E/F-K9 with Ver 12.4(20) T2The voip leg record always gives the network out of order (38) error and no call duration. So we can not have a record of the calling number with  called number and call duration.T...

What are my options here? Are there any versions compatible with x64?

(Prefer Alberto Montilla)Good day!We test equipment SPA2102 and we have problems in passing faxes.Fax works only in automatic mode without raising a voice session.Fax does not go with the reference in the manual mode on a protocol T38.When I try to c...

I use SPA962 phones connected to a 3cx IPBX. Firmware is 6.1.5a.When an inbound call is received by these phones, two numbers are displayed on the screen : the company phone number, and the caller extension number.Is there a way to have the caller na...

dial-peer voice 123 voipsession protocol multicastAppears this is not possible on a UC520? Anyone worked with this?

I have discovered a bug in the SPA8000 firmware with the 6.1.3 release. I have noticed that outbound calls will fail if we disable the unneeded codecs. If we leave the unneeded codecs enabled, outbound calls will not fail and will negotiate the corre...

We've got a SPA400 plugged in to 2 British Telecom phone lines. On shows a positive voltage on the Line battery level (around 50V) the other a negative level (-51V). We are having a few problems with line drop outs - but thought we should establish t...

Is there a way to change the delay before dialing ?The current one is too short, and the dialing is often launched before the user has typed the whole number.

HelloRight, I've installed my 2nd UC520 and this time it seemed to go a lot smoother than my last one :).  Then last night this lovely problem appeared.  When trying to load Voice Data within the CCA 2.0.(1) It just fails to load anything,  the box w...