We have a uc500 base config is with 4FXO 4FXS portsWe need to use a PRI to use some of the UCC functions properly.I have installed the PRI card but when I login to the system tru the CLI it is asking me to install a licence file? Where would I get t...
I searched this site, UC500.com, and cisco for any installation guides setting up a Qwest PRI circuit on the UC500, and specifically on the VWIC2-1MFT-T1/E1=We're always doing Cbeyond SIP circuits and now we have a Qwest PRI circuit.Does anyone have ...
I have set the time correctly for CUE and in CCA all devices are synchronized but when messages are left in voice mail it has the wrong time. How do I fix this or even check it?Thanks
When I use the recomended procedure in the provisioning documentationprofile.xml<flat-profile><GPP_A> 123456</GPP_A></flat-profile>openssl enc –e –aes-256-cbc –k SecretPhrase1234 –in profile.xml –out profile.cfgand I and add the relevant key to my pr...
Using a UC500 with 7.0.2 package and upgraded IOS to 24T and have just updated the 7931 firmware to SCCP31.8.4.2S but the time is showing an hour behind all the other non-7931 phones and phone system.
We're newbies with Cisco and we have a big problem. Our password to access our UC520 no longer works. It did work yesterday. Is there any way to reset it back to the factory default?
Hello All,Can I get some clarification on ephone-dn's?I was under the impression that with software pack 7.1.1-EA, you could have multiple ephones with the same ephone-dn assigned to them. Not using shared lines but as their primary extension.I can s...
We have a UC500 that is located in the Moutain Time zone, but we have remote users all over the country in different time zones. How do you modify the phone system or the CIPC so that the correct time for that specific user's time zone is displayed...
Is it possible to setup one to one NAT translations on the UC? I have about 10 outside addresses that I need to translate to 10 inside addresses. I tried using CCA but it seems to only allow translation of type of services to addresses. is this poss...
Hello,Can the UC520 support dual language for the auto-attendant, for example, giving the caller an option for Spanish or English?Thanks.
Hello,My ATA worked fine, but now it seems that it entered an infinite Power cycle loop. The power LED change from red to green and then remain green for about 12 seconds. After that the LED is off and the cycle started again. During this period I ca...
I'm trying to get a new WIP310 configured and seem to be missign a config file. System is working fine but when the WIP310 goes on-line it will not provision itself, phones display reads voice not configured and the log server only saysTFTPS:<<ac1e51...
I'd like to have multiple wireless phones (20+) and will have no need for the ethernet ports. Will the system and phone licensing be available without the 24 port switch attached? Thanks in advance.Michael Lorincz
I currently have my default config 7.0.3 on the UC500. I cant connect to the CCA with my static IP which is setup to where they match the default IPs networks. I use 10.1.1.1 and 192.168.10.1 to connect. Im not sure if it has to do with the access l...
Hello, I want update :CME-Support-Files-7.0.3.tarCME-Phone-Loads-7.0.3.tarI have install Windows but I don't understand how open TFTP with telnet.Its possible send by SSH ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: