Voice Systems and Accessories - Small Business

Wanted to see if anyone had any suggestions for places to pick up spare parts for the SPA525G2 devices.  Most of the places I found through the search only showed parts for the 7xxx series phones and none of the SPA devices. Specifically, I'm looking...

I would like to make a programmable soft key “vmxfer” for a cisco spa 504g that has the same functionality as bxfer but dials a * instead of  ##. The purpose of this would be to send calls strait to a user’s voice mail. I understand this would be don...

Hi All, Is it possible to transfer a call from line 1 to line 2 without dialing the full telephone number?  Can you assign lines Extension numbers? Or are there short codes? Anything like that? Thank you 

SPA112 fails to dial - log shows dialed number but then it fails to connect. After failure dialing the same number is successful. Rebooting device seems to be resolving problem for a day, next day reboot required again. Incoming calls are received ok...

I have a UC320W setup with no auto-attendant, and 5 phones that share two FXO lines for inbound and outbound. It seems that if you answer from any phone on either line during the second ring, the call drops. If you answer between rings, after the fir...

Hello All, We have the need to flash a custom ringtone to our phones here. They are mostly 504g with a couple of 509g. They are all running the latest firmware 7.6.2. We have the ringer sound as a wav file and tried using this utility that was posted...

On our SPA504Gs any of the custome Ringtones I upload through the Config Assisstant won't play all the way. It only plays the first 2 seconds oft the 6 second tone. I am converting them to 8bit 8000hz sample rate U-Law WAV. It uplads and plays fine ...

Hi, We have a SPA112 setup and working. I'm now moving onto finding out more about features and limitations. With regards to "Resident Online Number", is it possible to input multiple numbers in some way? I have tried ; and also ,  but neither worked...

Greetings everyone, I have a particular customer who is requesting that when a inbound call is received that it stays on the SPA 303 phones screen for an extended amount of time after hangup so they can copy the inbound call into a spread sheet.  T...

Greetings everyone, I have a particular customer who is requesting that when a inbound call is received that it stays on the SPA 303 phones screen for an extended amount of time after hangup so they can copy the inbound call into a spread sheet.  T...

Hi all, I have SPA525G (Colour Screen) handsets that were installed to run with the NBN (Aust)  network. When I had the system installed a Cisco (or Telstra) rep kindly installed some management software onto my computer to allow me to manage the han...

Hi all, I have SPA525G (Colour Screen) handsets that were installed to run with the NBN (Aust)  network. When I had the system installed a Cisco (or Telstra) rep kindly installed some management software onto my computer to allow me to manage the han...

I have recently purchased a SPA122, new in box, unit configured to Hughsnet service and need to access the setup to configure it for my service provider.  I was unaware that this was a branded unit before purchase.  Can anyone help??

I need a list of all my phones with serial, extension, and user.  we are running CUCM10.5.1.10000-7. Any help. the inventory lady is driving me crazy :)