VPN

Hello, I have a problem establishing a VPN connection to my University. After I enter my login data AnyConnect keeps on loading and loading on "Establishing VPN Session" and nothing happens. I do not get any error. I tried reinstalling it and manualy...

show vpn-sessiondb index shows who logged in currently.Is there a way to show users who logged in yesterday or last week?

Hi,I use AnyConnect 4.10.03314 to log on to several VPN gateways. Yesterday I started to get failed to load preferences for error message and did not get the logon prompt for any of them. Weather I used hostname or full URL for host address in the pr...

Hi guys.I ran site to site VPN between 3845 and 2811 routers based on Cisco " IOS VPN Config Guide" Manual and  I'm using L2 Service with 30 Mb/s Bandwidth from My ISP on One side (HQ) and 10Mb/s On the Other Side.Both of routers using onboard VPN ac...

Hi Guys, I'm trying to understand what's happening here. I can see Phase 1 UP, However no traffic flow. I suspect an issue with Phase 2. Following is an output of the below debug commands. This was working perfectly fine. And no changes have been mad...

Hello, is there a vpn client which is simpler than ciscoconnect for the user so that he does not have to enter the password every time they connectI configure the windows client integrating it works well but it seems that I cannot direct the users to...

Hello, I noticed that when I leave my pc on standby during the lunch break (only one hour) the Cisco AnyConnect Secure Mobility client I use for VPN services disconnects and no longer allows me access, giving me the following error: "The IPsec VPN co...

Hello is there a guide to migrate DAP to ISE?

Hi, thanks for reading. I'm trying to configure an ASAv and a Firepower 2120 to authenticate machine certificates in addition to our current auth method, which is RADIUS AAA. The normal RADIUS config works great, and has been, but the new test profil...

All, I know this command has been covered in a few places, but even after reading the documentation I'm confused about what it does. When enabled, does it permit the overlay (i.e. DTLS traffic and associated TLS) from Anyconnect clients towards the A...

I have one ASA with 3 wan, configured for internet access and site-to-site VPN with remote office. I'm not sure which WAN line is used for VPN traffic. How to check, and how to force a specifiv WAN for VPN traffic?. Fabrizio

We have an ASA-5506 that has a new network routed through a L3 switch on the inside interface of the firewall. Is there a way to include this network through the EZVPN configuration? It seems to only permit locally connected subnets. Thanks