VPN

Hi,In one of our remote location, we have a dsl connection that is not really good (slow bandwidth and goes down a few times). We would like to purchase some other dsl lines and to find a way to load-balance those lines. This loadbalancing will suppo...

Dear all,I have recently lost my syslog event for client to site vpn connections. At the moment the syslog server side is set up and the asdm is pointing to it. I have set up the logging filter as follows:I am not quite sure what I am doing here I mu...

Can I run ASA 5520 as Active and ASA 5510 as standby ?Regards,

Hellos,I have ASA5520 and I have configured two ISP on failover mode if primary ISP goes down backup ISP is takes over and internet works fine, but Site to Site IPSec VPN SAs remains on primary ISP, it is not renegotiating with backup IP untill i cle...

I want to automatically reconncet my VPN client in case of disconnection. I have made changes in PCF.ini file. but it is not working for me.In VPN client software I have[Main]AutoInitiationEnable=1AutoInitiationRetryInterval=1AutoInitiationList=ENOC-...

I want to automatically reconncet my VPN client in case of disconnection. I have made changes in PCF.ini file. but it is not working for me.In VPN client software I have[Main]AutoInitiationEnable=1AutoInitiationRetryInterval=1AutoInitiationList=ENOC-...

I have cisco 3845 with version 12.3(11r)T2. I am trying to configure it for remote access vpn Xauth.Follwoing is my configurationaaa new-model!!aaa authentication login default group tacacs+ localaaa authentication login console noneaaa authenticatio...

I have a VPN3000 concentrator that I am getting ready to replace with an ASA5510.  Looking to see if there is a tool or utility that I can run that will take the configration out of the 3000 and reformat it for thw ASA.  I have heard that there is on...

Need some assistance in trying to make Cisco Any Connect 2.3 standalone client work for Vista x64.Can't seem to make it work.  I don't think it is hitting the ASA at all, so the problem is local to my pc.Done:1) Updated applicable HOTFIX for vista SP...

Can anyone tell me how I can have multiples in the "Connect to:" dropdown on the AnyConnect VPN client.I have multiple sites I need to be able to connect to and it seems to only hold the last one entered.

We setup a VPN tunnel between 2 sites using ASA5505s.  We need to setup QoS for the voice traffic.  The problem is the voice and data is on the same subnet at each site.  Is this possible to do?I attached a network diagram.

Hello,Can a Cisco Router "1841" act as an L2TP client ?SincerelyIsmail