VPN

Hi allI am configuring a ASA 5510 to performing the hostscan for the sslvpn. Below are the versions using:ASA: 8.21 K8CSD: 3.4.2048Endpoint Assessment Ver: 2.5.19.1I have two questions:1. The endpoint assessment supports checking the anti-virus, howe...

Hi All,We have a PIX 515E pair in active/stdby (Stdby: FO only license). failover config...*********************failoverfailover timeout 0:00:00failover poll 15failover ip address outside 12.25.10.6failover ip address inside 192.168.33.3failover ip a...

Hi everyone, I'm a newbie in CISCO systems but i'm actually excited to work these brand. I started working in a company and they assign me the task to find out if there is a possibility to stablish a VPN tunnel between to sites that are connected to ...

Hi,I have created a Remote VPN in PIX 515E 7.0 and issue is we are getting connected to the VPN but not able to access the servers sometimes When i try connecting from my home its getting connected to VPN aswell as servers but when i try from remote ...

Hi netpros,I am just wondering if any of you know as to whether the VPN extension mode available with Cisco concentrators (PIX,ASA) can also be configured/supported when using Fortigates as clients and head end VPN server. As always .. Any experience...

HiI am trying to set up a VPN connection between two sites (configurations are attached) but no traffic is flowing through my tunnel. please help me

As the title stated I'm running 851w and I'm trying to setup a remote VPN but while I'm in the SDM and I click 'Launch Easy VPN Server Wizard' I get no response. I enabled AAA but after that I get no response from any of the VPN wizards. The only t...

Am unable to establish tunnel to ASA from Microsoft client using L2TP-Over-IPSec. ASA log shows port 1701 being discarded on Outside interface - even though ACL is there to permit.

I have configured an EZVPN Server on a router and everything seems to work fine with the exception of static NAT.I am using a static IP address to access a web camera and want this to be publically accessable so I have configured a static NAT stateme...

Hi,Existing setup is something like this.ISP-->Router-->ASA(Nat)-->Internal $ DMZ.All is working well.The Static nat is done on few of the public ip with private and placed in dmz.Now my requirement is that i want to extend the network beyond dmz som...

I am a teleworker. At my home I have ADSL connection with Modem, Cisco 871 security bundle router (1 wan, 4 lan). I want to configure Site to Site IPSEC for accessing Corporate data from my pc only on utp. And want other users at my home to access in...

Dear All Expert,Now i implement VPN site to site from HQ to ATM offsite, so the VPN connection is ok( i mean it is working so i can remote to ATM machine and ATM can process money too) but my problem is sometime ATM machine it out off service during ...

Hi,I have a question: I have 2 sites: Site A with a PIX 506 as a easy vpn client and site B with a PIX 515 as a easy vpn server . Both running 6.3 IOS.I plan to replace the Pix 515 with a ASA 5510 running IOS version 8,x. The setup of the vpn client...

Hello,http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00808cf897.shtmlFollowing this note I try to assign an asa group policy through our ACS. The only difference is ACS v5.I correctly set ACS to send the ou=...