VPN

Hello Everyone,we have a device sitting behind an ASA 550 that has a public IP address on it and has an IPSec tunnel coming in from the outside. Is there anyway to inspect the IPSec traffic for malicious content, etc even thought the IPSec tunnel is...

Hi, I'm trying to configure a vpn site2site between cisco 5505 and openswan. It seems that the configurations are ok but after the phase 2 succeeded the tunnel goes down... Here is the debug log. Any suggests will be appreciated!Aug 11 11:58:26 [IKEv...

Hello,I need help, I make a vpn tunnel between Router 1801 to Linksys BEFVP41, the ping it's ok between 2 sites but sql replication is fail, i have SQL2000 sever in HQ router and MSDE sql 7.0 in remote sites, in sql2000 server is setting up the NAME ...

We have been using Cisco VPN Client version 5.0.02.0090. We have had many users call into our Support line saying that the "Connection Entry Properties" information disappears like the "Host" information. Sometimes there has been instances where a us...

i want to configure Web vpn in the following scenario-authentication from the ACS ,& on the same Web vpn certain users will have the privilege to download the ssl client , other users don't have the privilege to download the ssl client ( work as clie...

What version of the Windows client supports IE 8 ? or is it not support yet?Thanks in advance

Hi all,My customer have a router with 3 ISP (each Link is connected in a interface different) and I need configure VPN Site-to-Site with Load Balacing and HA between theses ISP Links, is it possible? Someone can help me with this task? tks a lot,Rodr...

Hi! I need my public(static) IP address to be "bridged" if possible over to the LAN interface on my Cisco 876 router. This so an another router with public static IP on the WAN side(same subnet as the 876) can use the 876 as gateway.

We are using an 871 for a remote office. We need to allow contractors the ability to establish a PPTP tunnel to an outside Windows server. I do not administer the PPTP server, I only need to understand how to allow PPTP traffic thru the 871. Any s...

I am trying to configure web based VPN on my cisco 2811 router, I am currently running Ipsec vpn on it,, remote users connect to this router via cisco vpn client and use server resources,I am not interested in SDM configuration,,, command line config...

I have a working VPN tunnel between an ASA 5510 and a 1841 Router. I am having an issue with RDP connections dropping. I will get an initial connection, then it will drop after I start to enter the credentials (5 or so seconds). It takes 30 or so ...

I need to terminate 13 site to site vpn connections. 12 of them have T1 connection and 1 has a T3 connection. Will a 2811 router with the vpn bundle be enough to support the site to stie tunnels?

i have these error while doing remote vpn to my network: Aug 06 12:18:59 [IKEv1]: Phase 1 failure: Mismatched attribute types for class Group Description: Rcv'd: Group 1 Cfg'd: Group 2Attempt to get Phase 1 ID data failed while constructing ID

Hi,I am looking for S2S VPN redundancy solutions, 1.Can we have same crypto map applied on two different interfaces which are connected to different service providers.2. Can i use the same crypto ACL for two VPN peers.