VPN

All,I'm attempting to configure an IPSec VPN tunnel between a 3002 and 3015 concentrator. It's configured for network extension mode. The 3015 is behind a firewall (NAT device) . The 3002 is not. It has a public, Internet routable IP address. Upon bo...

Is there a way to limit what group has access to the email proxy? Thank You

I just got in a newer vpn 3002 client with version 4.7 on it. The older clients all have the ability to establish a tunnel when the vpn client is rebooted or network connectivity is lost. This newer client always seems to want someone to manually c...

Hello All,I have an interesting problem, PIX515e and VPN Client 4.0.2.d Basically when my remote users connect to the firewall they can access all resources except the following - Email and Internet ?Just to explain - The Email server resides on anot...

I have setup a new network with NAT (first time getting into this) and workes fine. I introduced a 3015 VPN Conc. I am able to establish a connection to another office but unable to connect to it from the local net. ex local net 10.163.0.x remote...

Currently, we have pix 515e as our VPN server and for our client side we install cisco vpn client to connect to our head office. My question is can we have 2 DSL line in pix 515e working at the same time?Is there is an equipment do we need to install...

Hello, We have a Cisco 2610 router with 8-port analogue module. The dialup users access to the modem pool and passes the RSA Radius server for authentication. The IOS version of Cisco 2610 is 12.0(9).Now we want to replace the older Cisco 2610 by Cis...

Where are the keys on the VPN Client stored? Do they need to be secured?

Hi,we have an C876 ADSL CPE (PPPoE) which is not able synchronise on the DSL line (CD LED keeps flashing). We have already replaced the CPE without success. However, a SOHO96 or a C836 work on this line without probs. Even the C876 work on other line...

I have a Cisco 2851 with a NM-1CE1T1 PRI interface that I wish to utilise for dialin. I have followed some configs on here, however cannot workout the correct line commands.If I try to add a line via i get an error that it is not supported in hardwar...

The documentation refers to Cisco EasyVPN under which the 837 can support 5 simultaneous, but it can support 10 simultaneous IPSEC tunnels. I need to support 10 simultaneous IPSEC or PPTP clients on this router. If I don't configure it under EasyVPN ...

I have been trying to get 2611 to work as a Terminal server to be able to reverse telnet to couple of routers. But I can't get it to work on the NM module, however it is working through the AUX port. This is the config of the router:Current configu...

HiI am trying to establish a VPN site to site from a PIX to a firewall Nortel. I have configured a VPN using IPSec between the PIX and a VPN Client. When I include the commands into the PIX to create the VPN Site to Site, it blocks my connection by V...

I am trying to add a backup address to my pix for remote access vpn. The Cisco vpn client 4.8 gets the information on the backup address. But when the outside interface goes down on the pix the connection will timeout and never use the backup address...

hi,we are using PIX 506 version 6.3 for our network. We have to do static NAT for the VPN connectivity with the client server. But when i try doing PAT i am not able to connect to the remote server. Can anyone help me out why this is happening.Is tha...