VPN

Hello,after installing the Cisco VPN Client (4.0.3 C) I get the following error message in the windows application log:TrueVector driver: Driver install or load failure: LoadNTDeviceDriver. Win32 error: The system cannot find the file specified.The s...

We have 2 isp connections (redundancy) with 2 different network addresses. We have a PIX 515E.Can we support the redundant ISP connections with only 1 PIX outside interface? If so, how dynamic is this? If not, can someone suggest an approach to su...

Does anybody know how to get to their LAN resources when connected remotely via the vpn client?I can connect to the gateway and get an IP address, but cannot ping or see anything on the LAN.I have tried just about every support site I can and am begi...

Hi all,If I had the following situation what sort of problems should I look out for?Router|100.100.100.1 /30||100.100.100.2 /30PIX|10.0.2.1 /16||10.0.0.2 /16ServerI have:nat (inside) 1 10.0.0.2 255.255.255.255global (outside) 1 interfacestatic (insid...

Does anyone know why this is happening? I can't ping anything from my laptop nic cards after I installed vpn client.

Hello,I have a pix 501 in a remote office. From there it does a split tunnel vpn to Corporate. When a client comes in and uses the Cisco vpn client to connect to their network from my location, they cannot. The pix is set for Nat. i have a linksys se...

Does anyone know if Cisco plans on integrating the ability to check if a remote-access VPN system is running pre-defined anti-virus software (similar to checking for a pre-defined Client Firwall being installed and running on the remote system)?Thank...

We have PIX 515 running as VPN server. We would like to know how to delete the VPN session. From Device Manager, We can see the session but on option to delete it.

Hi I have managed to get my IPsec encryption working using digital Certificates from MS CA server. But I am failing to usnderstand what is the use Auto-enrol command in Ca trustpoint configuration. As when I enrol my routers for cert, I have to suppl...

I have a cable modem that plugs into my PIX 501. I'm running 6.3(1) on the PIX. How do I go about creating a NAT to allow outside [specifically my work office] to connect to the web server I have at my house?I added these two lines to the config on m...

Im trying to set up a site to site VPN from our head office to a branch office. The problem is at the branch office end. It has an ADSL connection with a staic IP address on a cisco 1721 router with a PIX 506 sat behind it. The problem i have is ...

Creating a site to site VPN. I get the above error message when I apply the nat statementnat (inside) 0 access-list 120I also noticed that the traffic isn't being picked up by the access list as interesting and being forwarded out the vpn. VPN is bid...

Hi!I'm trying to do a LAN-to-LAN IPSec tunnel but i'm having a problem. In the VPN3005 we define the local and the remote LANs. In the CS1721 we have to define ACLs but we have to say wich networks "talk" to each other like:access-list 100 permit ip ...

Hi could you please get me started on the VPN config between two 1721 routers.Thanks in advance JP

Hi,I would like to connect a vpn 3002 as a hardware client, but the problem is that I have two internal networks , the networks on both sites aren't overlapping . How can I configure and annonce to the main site the two networks. Regards