Hi 4 out of 6 wireless APs connected to a specific switch have an unknown reboot problem. WLC Model: C9800-L-F-K9 WLC OS: 17.6.3 Uplink Type: 1G UTP AP Model: C9115AXI AP OS: 17.6.3 Uplink Speed: 1G UTP Power: AIR-PWRINJ6 Switch Model: C2960L-24T...
Forum Posts
We recently migrated to Fortinet Firewall in which we have seen an issue when any link goes down causing the AP to get disassociated from WLC and then we have to manually do shut-no shut to get them up. Even if we have any power outage in that case w...
I'm trying to install anew outdoor AP (4c:e1:75:4b:f1:20) but its not joining the WLCHere is the log, I couldn't console into it aswell,*spamApTask3: Feb 02 10:12:37.218: d8:b1:90:6e:ca:f0 WTP Event Response sent to 10.10.75.169:47418*spamApTask2: Fe...
Please Help!!!I have problem with WLC 5520 after update the Softwre.some client complain to me for WiFi alway relog in 10-12 minutesmaybe someone can help me to solved my problemI setup session timeout, client user idle and arp time out like thatSoft...
Hi, I am trying to configure three C9136I-ROW access points. I could give the primary and secondary controller details, but I cannot get them on the controller.Below is the error that keeps on popping up in my putty session,*01/31/2024 12:16:31.0404]...
I was surprised dACLs just barely got partial support in the C9800 series. The C9800 platform has been out for 4 years. Anyone working with an very old 5508 or any of the newer platforms preceeding the C9800 series had dACLs, fully functioning, inclu...
Resolved! Packet Drops and Low Bandwidth
In our company we use WLC Type Cisco Catalyst 9800-L Wireless with Software Vesi 17.6.4, and for AP type AIR-AP2802IConfiguration QoS 15Mbps per Client, not per SSIDThe problem is that when there are more than 50 clients connecting to the AP, there i...
Question: Cisco Cisco Mobility Express (ME) Model AIR-AP1832I-H-K9, Can someone guide me on how to set the management capwap AP power for it? Thank you all!
Hi,I have cisco 2500 WLC. Can we broadcast SSID to only Selected (few) APs in the WLC.Plz guide me.
Hi all.I am trying to connect Ansible to a WLC running AireOS, but it does not work at all.It used to work when usingansible_connection=localBut this is no longer supported in recent versions of ansible.Using Network CLI does not connect to the WLC.a...
We set up the controller in the catalyst9105AXI-Q in the EWC so that the catalyst9105AXI-Q can join as 20 child machines. About three of them will not appear on the Shopify admin. The controller says "The DTLS handshake has expired." The log on the s...
Hello,I am using a Cisco WLC 9800 L running 17.9.3. I am attempting to set up LWA. Everything is working well in the tests I have conducted, except for the WLC is failing to remember the MAC addresses of sleeping clients. As soon as a client disconne...
Hello everyone, could you help me with this issue? I have a WLC 9800 in a VM environment, it has a G2 interface in trunk mode passing some VLANs of my WIFI SSIDs. This interface is showing: reliability 254/255, txload 5/255, rxload 255/255. Could you...
Hello everyone,I just configured a 9800 and now would like to configure WIPs on several access points. Does anyone have an idea how we can set this up on this new model of wlc?Thanks in advance.
I want to convert the internal AP to mobility express. When I run the command ap-type mobility express tftp://192.168.1.1/ISR-AP1100AC-ME-8-10-183-0.tar the AP times out with TFTP details not provided, please try again. Is the correct file the .tar f...
