Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I have a question about configuring WLAN to VLAN mapping on FlexConnect Groups.Do the mappings that are configured in the FC Group get inherited by the APs when they are placed in the group?It seems like they do not.I am playing around in a lab with ...

Bill by Level 6
  • 6890 Views
  • 4 replies
  • 0 Helpful votes

Hai,     I need serious help on urgent basis. I am using LINKSYS by CISCO (WRT54G2) Access point wirh out any controller or wireless control system (WCS). Is it possible to connect this AP in mesh scenario, if its possible help me in configuring in m...

Resolved! Disable PMKID

Hi,   I want to disable PMKID in vWLC to reduce PMKID attack. In Mikrotik, I can do that by enabling Wireless/Security Profiles/default/Disable PMKID How to do the same in Cisco tq

nawir by Level 3
  • 3857 Views
  • 1 replies
  • 0 Helpful votes

Hello,   I have a customer that requires to have 1 gig of throughput for the wireless connection.   Assuming I have everything needed from the wireless side (client supporting 802.11ac wave, the proper AP), how should the wired network should be conf...

csocorro1 by Level 1
  • 2104 Views
  • 6 replies
  • 0 Helpful votes

I was considering using the Cisco vWLC to replace some 5508's that are doing n+1 HA redundancy, however, it seems this controller only supports Flexconnect local switching.  So if I have distributed Cisco WLC's with AP's operating in local mode, fail...

awatson20 by Level 7
  • 807 Views
  • 1 replies
  • 0 Helpful votes

Hi,   We have running issue on Cisco 8.5.135, what we are seeing that connected clients when they machine starts from sleep or idle, the wireless is connected but the IP address is not present. it seems machine has released the ip address and its not...

Hi Guys,Can I kick client who connected to the AP?And can I clear clear/remove client who no longer connected to the AP from "client monitor"?Thanks

Hello! I try to find best way to migrate wireless network based on 4402 and old access point 1131 to new WLC 3504 and 1852 access points. The problem is we cannot replace all access point very fast, the process of AP replacement will take some weeks....

patrashov88 by Frequent Visitor
  • 1058 Views
  • 4 replies
  • 0 Helpful votes

Hi,   I have two number of switches 1x WS-C3850-48P-S and 1 x WS-C3850-24P-S running on stack. I do have two number of 2702 access points that will connect to one of this switch. With this setup, can I run wireless? I see from the datasheet that  I c...

I've posted about this previously, and the past answers that were provided did help, but I'm still getting users complaining about Citrix and RDP sessions getting dropped. We've got a WLC 4402 with 15 1142n APs, spread out on multiple floors. The 440...

Review Cisco Networking for a $25 gift card