Wireless

Using InSSIDer I noticed there is a device talking on our network that consumes most of 6-11. It looks to be a 40 mhz channel. I was wondering what the benefit was of setting up your devices to use those 40 or 80 mhz channels? Is it signal strength? ...

I've 'wr erase' a few times but I keep getting the same result.  The last time I created VLAN2 in the web portal and it no longer is available to connect to and drops off the IP scanner.  Any ideas on what I'm missing?   I'm deep in the CCNA Route Sw...

Kindly let me know what are the implications to the Cisco WLC detecting rogue client and putting a "Threat" label against it? Does it block the client from accessing the networks or simply puts a label and let the client access if it can. This is rel...

Hey Guys How do you secure your switch ports when you operate access points in Flexconnect mode?I've read that 802.1x authentication is not supported on trunk ports.  Is it possible to use PEAP or another EAP-Type instead of EAP-Fast to authenticate ...

good day guys today we install an AP in remote site and we used the CAPWAP to define the controller , the AP found the controller but it doesn't go up and still in downloading status could support me how to fix this issue

Hi,   I tried to upgrade to 8.6, but a connected 3500 AP will no longer work. When I start the upgrade on the 1815i controller, I see on the TFTP server that the file ap3g1 is not found. With version 8.5 everything works fine and I see a lot more fil...

In my current environment, I have a single WLC 4404 and a handfull of 1142 AP's.  I am using 802.11a.   In one particular large room, I have 2 AP's that cover the room.  Both AP's are mounted on the opposite sides of the room.  One of the AP's (lets ...

I need to add more DHCP ip addresses for my production wireless network. Working with TAC I understand I can created another Wlan interface, create a group and add the respective Interfaces to that group and the ip address will be allocated round-rob...

I have cisco AP2802E as CAPWAPP and then i convert to be Mobility Express using AIR-AP2800-K9-ME-8-3-102-0.tar, i can convert that AP but when i access via CLI i have error " Warning : Missing TFTP/CCO params, Please Configure the Image Download Para...

Hi,Will it be possible if one AP1240 LWAPP enable bridge connection with other AP1240 LWAPP. Both are using external directional antenna. Please help

I was wondering if anyone has run into this problem.When using ethernet connected to WLC PAP will register.I am using a powerinnjector to power the AP and was wondering if this is the problem as it may not gettin power.I dont know how to test this......