Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi, Community! I've met an issue with security requirements needs to be applied on wireless infrastructure built on Cisco WLC 2504 and ISE (radius, CWA, authorization policy). The issue is how to force users, authorized by CWA and registered their de...

Iontzev by Frequent Visitor
  • 2153 Views
  • 2 replies
  • 0 Helpful votes

Hello everyone,   I have been trying to find an answer but no success so please forgive me if that has been covered in other thread.    I currently have vWLC (8.5.105.0) + 2702I setup at home/lab and have been using that with no major issues. The set...

Hi all , is it possible we have two mobility controller on the same network ?    because i have installed one of the mobility controller and when i am trying to install the second mobility and it will keep sending request to join the first mobility c...

EdwinThoo by Frequent Visitor
  • 2404 Views
  • 1 replies
  • 0 Helpful votes

need to ask if my pc has been hacked or virused becuase after my pc connected to network the pc consumed hug bandwidth and i didnt donwload any thing or open even browser  i check the netflow on the gateway interface also checked the output on gatewa...

We purchase multiple 5 AP adder licenses for 2504 WLAN controller, registered all PAKs and get the license files for each adder license.   To install/activate the license into 2504 WLAN controller, do I need to install the license file one by one in ...

Liong by Frequent Visitor
  • 824 Views
  • 0 replies
  • 0 Helpful votes

Hello, I have a question for you to solve controller's problem. I have just arrived in my company and I owe parameter a controller to understand the functioning and the credit note one of the change, because the former IT specialist has me to leave o...

SCAL by Level 1
  • 3296 Views
  • 14 replies
  • 0 Helpful votes

Hello, I'd like to ask few questions and appreciate guidance to help me in my solution design.   we have 11 nearby classes (as in the attached .jpg), we have four Cisco 1852e AP in hallway, each class wall is solid concert with wooden door, 25 studen...

Resolved! AP2802 PoE setting

I have a registered AP2802 and connected to a 3850 switch. The AP admin status is enabled but the Oper state is down. Th power level is showing 5(*) , clean air operation status is down.  Can you help in bringing up the AP? . The switch is not PoE, s...

yasseryy by Frequent Visitor
  • 17251 Views
  • 7 replies
  • 0 Helpful votes

Hi All,  Does 5760 support ISE posturing, I haven't seen any document regarding this nor any discussion in the support forum The ISE compatibility matrix says it is supported, has any one worked on posturing with 5760 Regards Nikhil

Goodmorning, Hopefully someone can help me out here. I've got our Cisco Prime Infrastructure 3.1 server running with (for now) an evaluation license. I got it synced up with a Cisco 5520 WLC, the Prime server recognises the configuration through SSH ...

Haye.2011 by Community Member
  • 8987 Views
  • 16 replies
  • 0 Helpful votes

hi   i read in this cisco datasheet : https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_01101110.pdf   this note in page 13 : When an AP in a Release 8.0 im...

Murad* by Level 5
  • 1393 Views
  • 2 replies
  • 0 Helpful votes

Hello Experts , i would really appreciate you guideline . Actually i am going to migrate an Aruba WLC to Cisco WLC . i would like to ask you guys please suggest me the best practices and procedures i should have to follow . Thank you all experts in a...

Top Solution Authors
Review Cisco Networking for a $25 gift card