Wireless

Single Access point with isolated External Antenna's

Hi, So I have a suite of rooms which for simplicity is a 10 X 10 meter main room with two 5 X 5 rooms bolted on one end (rectangle with the top third walled off and then sub divided in to two. The room structure is poured concrete with double rebar s...

how do you improve performance of Cisco HWIC-3G-HSPA

currently i'm using a Cisco HWIC-3G-HSPA card on one of my network Routers however Link is too slowwhen i transfer a big file (100MB) across link connection starts timing out is there a way i can improve on it's speed

WLC HA 7.6.120

Hello all, I configured 2 WLC 5508 with version 7.6.120 in HA, one of them had the management trought management-port (the primary) and the other had the management trought the service-port.When I setted SSO enable I lost the management to the second...

%CAPWAPPING-3-PKT_RECV_ERROR: 1 wcm:

I've installed 3650 as MA; wlc 5508 is MC. APs are 3702.Everything worked fine until yesterday. I've checked the log-entries and found the following error-msg, appearing every 30 secs:%CAPWAPPING-3-PKT_RECV_ERROR: 1 wcm: capwapPingSocketTask: capwap...

Resolved! wlc 8510 - v8.0.100.0 - APGROUP count how many APs

Is there a way of getting a count of how many APs are in an APGROUP either via CLI or GUI .This is for a confidence check. I can get a count of all APs with a certain name that should be in an APGROUP, but how do I see a count total how many are act...

WIreless limited access

Hi expects,I'm using a wireless controller 5508 and 1141 Ap.Ultimately all the AP is working as LWAP.Everything is working fine.But offen end user getting "Limited Access " .At that time network is connected but i cant ping even my gateway.Pls advice...

Aironet 802.11A/B/G PCI Wireless hardware update

Hi,Easy question, we are using, for a compact touch PC, a wireless card "Aironet 802.11A/B/G Wireless PCI adapter".Is there any update similar to this adapter with "N" or "AC" technology?I can't use USB adapters or PCI cards with the antenna in the p...

Cisco 1552I Power Cube

Is there any recommeded "power cube" that can be used to power Cisco Aironet 1552I , given an AC power outlet?Cisco Aironet 1552I do not support power injector AIR-PWRINJ1500-2...

Roaming causing ReauthC on anchored controller

Any and all help is appreciated..So I am seeing an issue where guest clients on an open L3 passthrough anchored wlan are having to reauth upon every roam. (intractroller) I scoured documentation today and found verbage of several variations of this ...

wlc syslog config

Hi Can anybody Pls share what are the config needs to be done for syslog & how to check WLC is sending logs towards Rsyslog Br/

VoWLAN with 7925G and FlexConnect - What are current recommendations and Experiences

Hi All, From reading current config guides etc I understand that VoWLAN should be fine with FlexConnect if APs at a given FlexConnect enabled site are in a common FlexConnect GroupI also seen articles including the following that recommend against th...

cisco PI alarms by group of ports

hi all, I need to know how can i apply alarms on group of ports if these ports have a utilization of 0% please advice thanks in advance

How to configure IP Address filter in Controller based Access Points ?

Dear Team, Configuration:i have 5508 series controller and joined the two Thin APs to the controller. WLAN controller is connected to PC where Multicast receiver is running for two Multicast IP addresses (IP1: 230.1.1.1, IP2: 230.1.1.2). Multicast se...

cisco prime Infrastructure alarms by e-mail

hi all, my Cisco PI1.2 not send me a notification e-mail with specific alarm if occurred twice and the first time is not cleared or deleted. i.e.if a switch is down it send me a notification e-mail, and this switch comes up again but i did not remove...

Resolved! Rogue AP Alarm in Prime

Hi, I'm working on Prime alarm and I'm wondering how to do this :1) I would like that all rogue AP not containing a substring to be friendly2) I would like that all rogue AP containing that substring malicious. Is it possible ? I can't seem to figure...

Wireless

Forum Posts

Single Access point with isolated External Antenna's

how do you improve performance of Cisco HWIC-3G-HSPA

WLC HA 7.6.120

%CAPWAPPING-3-PKT_RECV_ERROR: 1 wcm:

Resolved! wlc 8510 - v8.0.100.0 - APGROUP count how many APs

WIreless limited access

Aironet 802.11A/B/G PCI Wireless hardware update

Cisco 1552I Power Cube

Roaming causing ReauthC on anchored controller

wlc syslog config

VoWLAN with 7925G and FlexConnect - What are current recommendations and Experiences

cisco PI alarms by group of ports

How to configure IP Address filter in Controller based Access Points ?

cisco prime Infrastructure alarms by e-mail

Resolved! Rogue AP Alarm in Prime

Meet and congratulate the February 2023 Spotlight Awardees!

Renew.cisco.com just got refreshed, and it will make your life easier!

Announcing Resources That Guide You to Success

WLC 5508 8.2.170 and ISE 3.0 Authorization Issue.

Join the Early Field Trial -- Cloud Monitoring for Catalyst Wireless

CN UX Research Panel Giveaway 🎧🎁

Cisco Catalyst 9800-L IOS XE and End of Life

Configuration of dhcp at c9800 wlc

Adaptive FT in C9800

C9800-CL multiple VLAN SVIs same mac

5520 to 9800 migration and AP image certificate issues