Wireless

Hi,    I have controller and the access point are on the subnet. Due to some requirement i want to statically add the access point ip address and controller ip address into the AP. Kindly suggest me the suitable commands for this. i used the followi...

It was GUI upgrade of our controller WLC2504 with software version 7.4 First of all I downloaded software image AIR-CT2500-K9-8-0-140-0.aes via GUI. All checks were ok. Then there were two basic steps 1) "Reboot" 2) "Save and Reboot". Ok, It's gonna ...

The manual on this has 3 connections for the power DC In+ DC In- and Ignition. what is ignition

Hello Team, I have a strange issue, short description below AIR-CTVM-K9-8-2-141-0.aes AIR-AP2802I-E-K9 I configured the interface under  controller- interface, then I created an SSID and I binded it to the interface After the AP joined the controlle...

Dear all, I met one problem when testing Cisco 1852i with Mobility Express. There're two 1852i called AP1 and AP2. AP1 is running Mobility Express and AP roles. AP2 is only AP role. At first, everything is OK, but I find AP2 could not contact to M...

Hoping there is a simple answer to this. We have a wide spread hospital network over several campuses and are having issues with Apple IOS devices not being automatically redirected to the ISE Express AUP page after connecting to the open SSID. Andro...

Hi Team,                We had purchased 3802i model Access point recently, we would like to work with standalone mode, so i tried to download the Autonomous IOS from cisco website, but this software doesn't available. can someone do help to resolve ...

Hi All, Could anyone please help how to schedule a Report from Cisco Prime for Down Access points. All access points are Lightweight (Associated with controller ) Model name :- AIR-CT8510-K9 Cisco Controller Software name :- 8.0.140.0Prime version ...

Hello there I bought Aironet 2702e AP from Cisco and i just couldn't configure in a normal way. I try to move  to autonomous using tftp and i followed every steps but i just got this error. %Error opening tftp://255.255.255.255/ap3g2-k9w7-tar.default...

Hi,  i have using Cisco WLC 2504 with Version (8.1.102.0) and 1832 access point with image (ap3g2-k9w8-mx.153-3.JBB). When i connect the AP with the controller POE port its boot up but didnot associate with WLC. -> I have configured the management ...

Hi, i was checking the documentation on the 2500 WLAN controller... it states "The Power over Ethernet (PoE) ports on the Cisco 2500 Series Wireless Controller will not support directly attached APs." ... if that is true, what are those PoE ports goo...

Hi! I have an issue with my WLC2504 box. After some manipulation of the box : - I cannot reset the config : it comes back to the config I had set in - I cannot use the Console port any longer (?)  - the only way to access the console mode I have, i...