Wireless

Hello. i have saerched but could not found.The controller and Access points works fine, but i have a problem like this: when i have a static ip address on cleint device, i can not access anything. when i set ip address to dhcp it is working  fine wit...

Hi I think my router only has 2.4 Ghz broadcast  following is from show controller Dot11Radio 1 command Is there a way to upgrade or add the 5Ghz frequency? interface Dot11Radio0Radio ATHEROS AR5212, Base Address c84c.7519.77a0, BBlock version 0.01, ...

       RADIO0-802.11N2.4GHZ  STATUS     DETAILED STATUS     SETTINGS     CARRIER BUSY TEST     Hostname  ap1ap1 uptime is 32 minutes     Network Interfaces: Radio0-802.11N2.4GHz Settings Operating Mode:MixedEnable Radio: Enable Disable Current Status...

Just got a Cisco 3501 AP, Did not know it required such complex configuration. If someone could/would help out. here is what I am askingI have a cisco 3650 switch NICE- It has the controller for this wireless AP>  I have no ideas how to set that up, ...

Hi, I have an existing setup where in i have a 4400 WLC and AP 1242 registered to it.I had to replace the WLC with a new 5500 WLC. I tried registering the the 1242 AP with this new controller but i'm getting the following error message: AP0026.0b4d.0...

Hi folks I have been trying to figure out why my download speeds are not as fast as I expect.  I have recently installed a Cisco 2702 in place of my Cisco 1041 AP.   I have the AP plugged into a Cisco 1921 router via a non Cisco dumb 10/100/1000 swit...

We have a site that wants to "bridge in" a small building with no fiber run to it. That building is only 400-500 feet from a fully connected building, so we are suggesting they use a pair of 3502e with directional antennae mounted outside. The AP in ...

We have 2500 WLC and planning to USE ISE for AAA functions. Before we start I would like to know if 2500 has any limitations with

Hi All, The config file in my controller shows this two commands:config network broadcast enableconfig network multicast global enable Running 'show network summary' gives me this:Ethernet Multicast Forwarding............... DisableEthernet Broadcast...

Dear Community I manage a topology based upon wlc with different licensing sizes that is getting centralized. previously there were wlc in every location, the target is all on flexconnect with a pair of wlc at a central site.does anyone know how to c...

I have a new installation of a WLC 8510 running 8.0.110Now we need to deploy 300x AIR-CAP702W that has 4 ethernet ports We need special config for each of the ports - is there a way to template the install so we don't have to change each AP individua...