Wireless

Dear All, I am facing some problem on WLC (2504) with AP (1702) mobility  doesn't work properly. When users moving one AP to another AP under same WLC users couldn't connect until disconnect, Users keep before AP signal on the same floor.  Thanks & R...

Hi, We are planning to upgrade WLC hardware 7510 to WLC 8540. I did`t find any document fro this migration. Currently we have around 5000 APs assiciated to this 7510 WLC what steps I need to follow to upgrade it. I`m having 7510 device backup.

What are the recommened parameters to mitigate Security vulnerabilities such as sslv3 poodle? Cisco Controller) >show network summary   RF-Network Name............................. CLFWC-Wireless Web Mode.................................... Disable S...

Hi! I have cisco WLC and three cisco 1522 access points. The problem is that only one access point has two radio interfaces, so it has 802.11a and 802.11b/g. Radio Interfaces Number of Radio Interfaces 2 UP Radio Slot# Radio Interface Type Sub Band A...

Hi All,Can help me advise on what is the correct configuration of Cisco SG200-26 Gigabit Smart Switch and TP-Link WR940N (Wireless AP). I have two TP-Link Wireless AP connected to switch Port 2 and Port 5 and have the same issues.On the Switch, Port ...

Document says Number of radio of 2800 series AP is Dual (XOR and 5 GHz). I am not clear what means XOR. Why not 2.4 ? Please explain me, any guru. Regards,

Hi, I am trying to upgrade our Cisco AP 3802E to the last mobility express image 8.3.20 and I am getting the following error #######################################################################   99.3%Image downloaded, writing to flash...do CHECK_...

Hi, is there anyone to see when a particular AP's config was last changed/applied? Software version is 8.0.121.0  The WLC has many APs connected, some of which have a different config to the rest, I am trying to find out when this changed.

Hello - I have a Cisco M20 Valet Plus wireless router (from 2013). I also have a new Arris Surfboard modem (SB6190) - my ISP is Comcast. For the last month or so, my wireless Internet connection has gone from full access to limited access. While in l...

Thanks in advance Jean-Luc

I have environment wlc 5508 and ap 702w 250 units config flex-connect mode WLC Firmware 8.3.102.0 WLC IP:172.18.210.1 WLC and AP connect same site  wlc and ap same ip subnet and wlc enable dhcp for ap Work!! I found problem many ap randoms disassocia...

We have just started to use the OfficeExtend 1810 AP solution in a variety of different scenarios, and they work fine within certain restrictions.  One area I am just scratching my head about is the apparent inability to manage the link speed and dup...

Is it possible that a 802.11n client to join to a 802.11ac AP configured with 80/160Mhz channels? If yes, what is the behavior of the legacy client?