Wireless

Hi there , I just set up a virtual WLC and configured Aps with 3 SSID. I configured APs in flexconnect mode, since with local mode , i couldn't see my SSIDs broadcast. Now most of users , aprox 90% are connected, but 10% cannot see the SSIDs . It's n...

Hello netpros, Has anyone tested the dhcp option 82 insertion in bridge mode? Can i safely assume that this feature crafts the dhcp packets as if the wlc was configured for proxy mode? Thanks

Our school is running the 5508 Controller with 3702 APs. Basically one AP for each classroom. There is one teacher keeps complaining the performance of the wifi connection when there are more than 20 iPads or Macbook Airs connected to the wifi runnin...

I have a large facility where Cisco 3500 Series AP's were installed.  The area has some dead spots and needing additional AP's.  As you know 3500's are no longer available.  We are currently using 3700's in other facilities.  My concern is mixing the...

Hi, I have searched the knowledge base to try to understand if this was something already answered. Unfortunately, I cannot find a suitable answer. I have WLC5508 with soft version 8.0.115.0 and some mobile phones cannot connect. Most of them are And...

Hello, AIR-AP3702I-UXK9 (SW 8.0.115.0, country code UA)  has constant blue indicator during normal operating, after installation RM3000M indicator has randomly blue flashing. From used controller WLC 2504 do not recognize any issue with AP or module....

Is it possible to profile Wi-Fi users by authentication type (i.e. EAP-TLS, EAP-PEAP) with ability to segment via VLAN or through the use of ACL’s restricting access for non-corporate devices (BYOD) and corporate assets? For example, EAP-PEAP users (...

I got 1852i, loaded CME, seemed ok, but was missing the stuff my 2504 has on it at work, so I hunted for a good buy on 2504 bundle picked that up, set it up, with 2702i's, plan was to add 1852i to it as an AP (demote it down) that didn't go so easily...

Hi, Is anyone know if it is possible to paint the Cisco AP 1572 Outdoor? Is there a Cisco document that specifies that ? Thanks Hervé

Hi,I'm trying to reg. some licenses for the new version Prime 3.1, but I have some issue looking up the Product ID and the Serial Number.The menu are not like the Prime version 2.2 or version 3.0. Does anyone know where to lookup the UID information?...