Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Hi everyone,The WLC works just fine using web authentication against AD using LDAP. No complaints there.However I can't figure out how to specify multiple User Attributes. Right now I use "sAMAccountName" but I want to use more than one concurrently....
Resolved! directing an AP to a specific WLC
We have recently implemented a N+N controller configuration. I expected to configure the test APs High Availability option with a primary controller of the new WLC and secondary as the current production WLC, then reset the test AP to have it join t...
Hi, There is a WLAN for Guest users with Session Timeout of 65535 sec and User Idle Timeout of 28800 sec. The WLAN uses PSK as Layer-2 authentication and Web Auth as Layer-3 authentication. Authentication source is locally created users on the contro...
Dears, when i use debug capwap errors enable this appersspamApTask5: Feb 05 12:31:52.003: [SA] f8:4f:57:bc:64:e0 ApModel: AIR-CAP2602E-E-K9*spamApTask5: Feb 05 12:31:52.003: [SA] f8:4f:57:bc:64:e0 ApModel: AIR-CAP2602E-E-K9*spamApTask4: Feb 05 12:31...
Resolved! cisco LAP 2602 can not join Virtual WLC
dear all, i just install Virtual WLC and i remove WLC 2504 , i install & configured it , but LAP can not join. it was work fine with WLC 2504.i used the same network topology with the old WLC.i receive this error logs.*spamApTask4: Feb 04 06:01:30.08...
Hi All, I am facing an issue with our AP. We have following software versions WLC Software Version 7.4.121.0AP1 IOS Version 12.4(25e)JAM3AP2 IOS Version 15.2(2)JB3As per Cisco documents, WLC software is compatible with both AP's IOS version. B...
Resolved! How lightweight Accesspoint works?
Hi all, I have a very basic question, how Lightweight access point work after joining WLC. when client will connect to AP after successful authentication how client device will work, every time when traffic for that client have to pass from WLC or n...
Hi,One question regarding to add a device / WLC Controller into NCS 2.0. I done this in the past with NCS 1.3 without problems but now I don´t know why but if I add a device into the NCS 2.0 I get the the message CLI Failure / timeout.I doublechec...
I am trying to improve my redundancy scheme and want to build a VPC on my 77ks to support my 5508 WLCs. Is there any reason not to do this?
Resolved! AP Group
I'm having issues with a newly created AP group. There will only be one AP in this group and will be placed at a small branch office. I've successfully created the WLC interface, SSID etc and can connect to the SSID, obtain an IP address from that VL...
Hi all,We have a scenario, we have cisco 2504 wireless controller in our network with 75 access point. Now we want to add more Access Point for that we have to add wireless controller but now question is how?How access points will be added to wireles...
Resolved! "Cisco WLC2504" mDNS in older firmware
Hi,Customer is implementing AirPrint on their site. Is it possible to open mDNS on a "Cisco WLC2504" with an older firmaware (7.2.110.0) without that option?Or is it any workaround to the problem ? RegardsErik
We are currently getting the attached error message when trying to establish a VPN connection with the anyconnect client in Google Chrome. Can someone please help us with the solution? We are not getting the security pop up to launch the Sun Java a...
I have an Cisco Prime infrastructure with a 2.1.1 version, I created a new campus, a new building, a new floor after that i want to add access point in one floor i can add 4 access ponit but in other one floor I add first 3 access points successful b...
I have an Cisco Prime infrastructure with a 2.1.1 version, I created a new campus, a new building, a new floor after that i want to add access point in one floor i can add 4 access ponit but in other one floor I add first 3 access points successful b...
