Wireless

Hi, Previously I have been able to enable 40MHz Wide channels on the AC module for 3600 access points as AC would be seen as a separate interface. With a 3700 Access Point the AC module is integrated and hence the AC interface does not show up separa...

Hello, I have a few 1142 APs (not the LAP) and have some phones that are having issues roaming. They seem to wait until there is basically no signal before switching APs. Both APs are setup the same and are on different channels. Same security, SSID ...

I have 10 interfaces in the interface group, all of of them are /23. Can I add a new segment /22 to the same interface group. Would the controller allocate to the larger interface once the smaller ones are filled? Thanks, Jose Zafra

If I am using AC power to power the AP, which lead goes to which terminal? The terminals are only labeled HOT1 and HOT2. Any experience would help. Thanks

I am following this to the letter  http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/109597-csr-chained-certificates-wlc-00.html I have generated a CSR and got back a signed cert - however when I try to generate ...

Does the 1700 and 1800 series WAPS need the controller to  run or is that just to configure the device? Can you configure the device by connecting to the management port? I have a client who is looking to purchase a couple but does not need a control...

We would like to use 1 controller as the Primary Controller, but we have a large number of AP's on the "Secondary Controller".  Is there a way change a large # of AP's globally on the WLC or in Prime.  Thanks in advance.  Mike

I can not connect to the AP 1602i, Already tried several times via console, but I can not connect, when I connect to a dhcp server he gets an IP, but I can not connect via http, ssh or telnet.Already tested on various browsers and already gave severa...

I have an AP 1602i that just came in but can not access it via the Console. I put it in the net to catch the DHCP but it exchange IP every 1 ~ 2 minutes. I do not have parent in my environment. One would have any idea what it is or what to do to acce...

Hi, What are the differnces between in choosing option 1 and 2 in the wlan profile 1)layer2 security WPA2 + WPAAUTH Key Mgmt : FT802.1X 2)layer2 security 802.1x AUTH Key Mgmt : FT802.1X Thank you 

Hi guys, I have setup one wlc with latest software with two AP. They are joining my controller but they don't have green light they blinking red green and "black"any ideas? i have setup 2504 with 2602 before with no certain problem kind regards

I have a WLC 5508 that runs about 37 AP's right now.  I need to shut off the 5hgz side of the Dual Band to do some testing.  How do you do it?

HI, I've recently purchased of ebay a Cisco 1112 Secure Access Control Server CSACS-1112-K9 as an additional piece of kit to be used with my cisco learning in my home lab. I didn't get any recovery Media, I was wondering if anyone knows or has a vers...