Wireless

Guysi am having wlc(5508) running with 7.0.220.0 and i am trying to upgrade to recent one 7.6.110.xwht are nearest release i need upgrade before i ugrade wlc to 7.6.x.x?any URL with refernce to this?which is recommnaded recent code?Thanks 

Hi, I'm testing out a vWLC and have set up 4 APs all in FlexConnect, the Controller is at my central site and the APs are located in Branches across countries. Everything is working fine except for this one AP which keeps rebooting. (1602 series).So ...

How can one restore a backup from Prime 2.2.1 to a replaced WLC 2504 that has minimal configurations and am able to get into it remotely GUI and SSH?I see the RAW configurations but it looks like "config" needs to be added to each of the many lines.A...

Does anyone know of a report in Cisco Prime Infrastructure that would provide a count of all alarms of a specific type for a specified interval of time, such as disassociated APs for the past week? It seems the only thing that comes close is the AP i...

Where can I find "unknown devices" in Cisco PI 2.2 under the converged view like I can in the classic view?

I have a customer who is telling me that they are using Windows phones and they need PKC turned off.We are using WPA2 - which seems to me turns on PKC automatically.Is there anyway I can turn this off ?If so where ? I have been all over the controlle...

Hello, I am new on Cisco area and I would like to take data from a Cisco wireless controller(If it is possible). I little confused where to look and where to read and how to communicate with Cisco machines(I use Java). I would like to guide me where ...

Hello, I have Cisco WLC 5508 configured with one SSID taged to one VLAN.  Post connecting wifi, general internet is working fine for all users. But, communication between clients in the same vlan it is not happening. Controller model:  5508AP: AIR-CA...

Hi Guys,We have around 75 Laptops, and we must migrate from SSID A with WEP to SSID B with WPA2/.1X.I have enabled B since a week or so, to run in parallel with A, The Server Team reconfigured the AD Group Policy for all PCs so that their primary SSI...

All, I have been trying to find a solution revolving around getting a Mobile Xray unit on the wireless network. Our first attempt was to use a small business RV180W to create a bridge. It appears this may not work as all the APs are using LWAPP. We n...

Hi,On the business, we have 4 access point WAP371 Wireless AC/N Dual Radio Access point with single point setup.Firmware Version (Active Image): 1.2.0.2Firmware Version (Non-active): 1.1.2.3Connected to Cisco switch SG300-10PPAll working good except ...

Hello probably a beginner's question but how can the 8510 controller support 6000 APs in centralized mode when it only has 10Gbps while the 5520 supports 1500 Aps only and has 20 Gbps ?

Hey Guys, I am having strange issue,I am using RF device WT41N0,and was working before with PEAPand at a sudden it stopped working,but if i change PEAP to LEAP its working. When i tried PEAP its not authenticating on wlc-5508All config perfect on wlc...