Wireless

Hi folks, I am trying to downgrade an 2600 ap using my mac book air 10.10.2 with IP address 10.0.0.2/28 + the built in tftp server. file name is "ap3g2-k9w7-tar.default" with 666 rights. the tftp root folder also got 666 for everyone. when I am tryin...

Hi all,   recently we migrated AIR-LAP1131AG APs from a 4402 WLC running 4.1.185.0 release to a 5508 running 7.6.130.0. After we did that some clients constantly disconnected and reconnected. I strongly assume it has something to do with the addition...

Hi,I just formatted my PC, Installed Win 7 Ultimate and am now trying to connect to my work PC, using Cisco AnyConnect Secure Mobility Client.I'm getting the error "Connection attempt has failed due to network or PC issue" I was connecting fine befor...

Dear All,I'm having a problem with establishing EoIP tunnel between two WLAN controllers on different subnets. Below is a summary of the setup:--There is no FW between the controllers-One controller is 10.2.30.250 (Remote) and the other one is 10.3.3...

Hi, I Have 6x WAP 561 - Clustered. Every single day various phones, tablets etc are losing connection to the WAP. Seems to happen more with apple devices.Today it wouldn't even let me connect stating the password was incorrect - it wasn't!  Heres a s...

hello alli have a questionin one of our client location we are unable to access the autonomous cisco 1602 ap(it is showing limited connectivity) this problem is only showing in the laptop which have windows 8.1 installed all other system are able to ...

Hi,seeking help to reduce our ISE licensing cost, actually we are out budget and we planning to order ISE licenses less than what we required, and looking for efficiently using the same, is there any way, i mean if we reduce "user idle timeout" is it...

We have an outdoor AP that we want to bridge to another one that is also outside and connect to our WLC 5508. I see a lot of data for connecting via a layer 3 network, but nothing yet on a layer 2 network (which we run). Can anyone point me to some d...

Hi i have a virtual WLC (AIR-CTVM-K9 with version 8.0.115.0) install on esxi , seems to work fine, and i manage to join the controller with AIR-2702I AP But i don't understand when APs are in local mode i don't see at all any of my WLAN , seem that A...

Having a ISSUE with Iphone and Ipad not connecting to WIFI on guest keeps timing out using WPA AES any  suggestions ?Will try Open Authentication This problem is intermittent the Debug attachment shows a connection failure  

HiThe AP 2700i, it is better to be wall mount or cell in which position give long/strong signal?Thank you

Hi !I see on some places that on the WLan Controller have to be an special configuration for the MacOS devices (all iphones, iMac, etc of Mac). That's because on my WiFi all of those devices experiment slower to connect to a WLAN with WEP security.So...

Hi all.I have acquired a used AIR-SAP1602I-A-K9 that came with a existing configuration and a secret password.I have tried to search the web for a guide on howto reset the password / reset factory default so i can clear config andset a new password. ...