Wireless

Just a question as to whether or not my wireless lan needs to have this enabled or not on the lwapp controllers. It currently is and wanted to disable it during my next IOS upgrade if possible. We have a strong vocera deployment which is working dece...

wireless network has 10 AIR-LAP1252AG-T-K9 joinned to wlc controllers AIR-WLC2100-K9.They are rrm configured.After a site survey I have observed a very low signal from these APs.At 2m apart from one of these APs it is almost impossible to maintain an...

Hi guys,I have a faulty secondary 7510 controller (on HA) and going to replace with a new one. How do I go about this?What steps should I take?Anyone done this before? Thanks in advance. 

Greetings, id like to deploy some 1530i access points in bridge mode between two points located ~250m apart, however i'm unsure of the range these AP's will support using the internal antennas or whether the beam with is small enough to cover the dis...

 What is best way to handle or setup wireless connection for a small branch office with less than 10 APs?  Management doesn't want to spend any money to install a local WLC.  Those APs will communicate back to two WLC 5508 in Data Center.Should I use...

Hi Cisco TeamI would like to confirm cisco 5700 series wireless LAN controller can be worked with other vendor AP.I have Aruba AP and Ruckus AP that can be worked with Cisco 5700 Series WLC.Please give me help to buy cisco WLC.Best Regards 

Hi all,Can anyone advise if this device runs Linux or OSX based software?1900 series (1921) integrated services router I have been asked to check if this hardware is possibly at risk from the shellshock bug. Many thanks,James

Earlier this month Cisco released a new autonomous IOS for the 2700 and 3700 access-points. If I look at the release logs, they reference to a new 1700I access-point:Support for Cisco Aironet 1700 Series access point- This access point is built on 3x...

Hi,I am having issues with wireless client sticking to its existing associated AP until the connection speed drops to 1 Mbps or the client dis-associates. At this point the client goes out to join the AP its closer too. Its a Warehouse environment wi...

Hi Folks, I'm currently working on a post site survey for a hospital to see what there coverage is like.  They want it to be VOIP and RTLS ready.  I'm looking for ideas or advice, especially in how to cover the elevators and stairways in each floor? ...