Wireless

Good Morning everyone,  In cold area -3 inside a warehouse I am trying to connect  a mobile printer ( Zebra RW420 ) to cisco access points of model AIR-LAP1242AG-A-K9  and AIR-LAP1252AG-E-K9  which are woking through WLAN controlar version  6.0.202.0...

Helo!I have few controllers and more than 100 ap's. When I connnet ap to the ppoe switch (cat 3560) som ap's detected as ieee pd device and not seen by cdp. This ap's received ip addreses from DHCP and I can ping this device but can not registred thi...

        I dont see any current field notices for the 2500 Series WLAN Controller.http://www.cisco.com/en/US/support/tsd_products_field_notice_summary.html  However, my supplier (MJ Systems) is telling me that they've started processing 5+ RMAs based ...

My Light Weight APs 1262N-N-K9 APs are not being discovered by CT 5500 controller. I am using a Cisco Catalyst 2960 with PoE switch to connect Light Weight APs to Controller 5500.Can I use the 5500 controller's internal management interface as DHCP s...

I have taken over the support requirements on a wireless network utilising lightweight access points, a 5508 wireless LAN controller and a Prime Infrastructure NMS and it appears to be underperforming.  How can I display the transmit/receive retry an...

Dear All, I am having a problem with WCL 5508 and 3750 cisco, we are gettin a long ping time, it doesnt good working, then our same clinet doesnt take a Ip address From 5508 dhcp scope. what can i do about them. ping time is so annoying...

Hi,We are using CISCO WLC and broadcasting a number of SSIDs. What we want to do is to block some spesific users to a spesific SSIDs while letting to connct to another SSID.Dows anyone have any idea?

Dear All,I have 2 WLC associated with Prime Infrastructure 2.0 i faced a problem when Edit the interface or add new interface in the Ap group in WLC and loggin to prime infrastructur  i found the AP group without any Editing and with the oldest inter...

If the root account of Prime Infrastructure is compromised, can it be used to manipulate user tracking data or the appliance database records ?

If I have these two models connected to 7500,AIR-CAP3602I-Q-K9 and AIR-LAP1142N-P-K9I need to enable theJapan 2(P) - enabledJapan 4(Q) - enabledcorrect?Reason is I am receiving reports of users not able to connect intermittenly, especially near the 1...

Hi,Bit of an odd one here...Configured an autonomous 1602 Access Point and connected to the LAN. Once connected it prevents users from outside the LAN connecting in. When the AP is set to DHCP, experience no issues at all. The config of the AP is bel...