Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|

Labels

Forum Posts

I've got an AIR-ANT2506 external antenna mounted on the side of a metal building.  Hand-held Teklogix scanners connect to the AP and scan material outside.  What kind of coverage range can I expect from the AP?  Also, what's the recommended height fo...

All,I have several autonomous 1240ag AP's that I need to enable a second ssid(Guest and VLAN2) for guest access and while I have configured the AP's according to the driections, I am not able to connect to the second ssid(Guest), but it is broadcasti...

Hello,I have a problem with my Access point AIR-LAP 1041: when i try to connect to it via console port, i can't write any command it look like there is any connection (i use putty to connect).Is't a hardware problem or should i make a reset?thank you

Hello all,I am confused about the cisco docs:What is the minimum WLC/WCS version to support WISM2 controllers ?The datasheet of WISM2 says "minimum 7.0.116.0"http://www.cisco.com/en/US/partner/prod/collateral/wireless/ps6302/ps9798/ps11634/data_sheet...

gnijs by Level 4
  • 900 Views
  • 4 replies
  • 0 Helpful votes

I Have a Cisco ASA configured to filter the wireless guest client subnet using websense. The guest wireless lan controller is in a dmz on this firewall. the websense server is on the inside. I have a wism on the inside with the controller in the dmz ...

mickyq by Level 1
  • 1456 Views
  • 0 replies
  • 0 Helpful votes

Hi, I have three AP but one one is connected with a network cable and the other work on a repeater mode. I need to create two vlans which will broadcast two ssid one for office and one for guest. I know you can't create multiple vlan on a repeater bu...

Hi ,Can we use AIR-AP1142N-A-K9  for India Domain ? , as per the compliances it is –N . What is the   technical difference between AIR-AP1142N-A-K9  and AIR-AP1142N-N-K9, both the AP  configuration guides are same will it work or not ? Regards

Hello All, I have 10 Ap´s in a building under a WLC5508 with CleanAir activated, however when the users, turn on a MW oven, the clients located near, lost completely their connections.I have activated the EDRRM, but the interference is in all channel...

Review Cisco Networking for a $25 gift card