Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi everyone,I got a situation. We had our wireless mesh network running with 4400 Controller and 1510 A.Ps. Now that we have bought new 5508 Controller (with SW: 7.2) and 3600 Indoor APs, we are unable to add legacy APs on our new controller. After a...

azhar.corvit by Community Member
  • 1008 Views
  • 1 replies
  • 0 Helpful votes

Hi all,can someone explain how to configure anchoring on a 'remote lan' wlan for the OE-solution?That's my setup:- DMZ:2504-CTR with code 7.3.101.0- Internal5508-CTR with code 7.3.101.0I've configured two WLAN's and anchored it to the internal Contro...

Hello,I have a problem configuring ClientLink on a FlexConnect local switching AP (3602i), the problem is that I can not see the clients that are using the ClientLink feature when entering the show interface dot11radio 1 lbf rbf command, the AP shows...

Hello;I have a problem with wireless phones are brand ASCOM. Are supported by Cisco. The problem is that, without moving your site, you lose your coverage and 3 seconds back. The configuration of the WLC is recommended by ASCOM. The wifi network is c...

jimontoro by Level 2
  • 22150 Views
  • 13 replies
  • 0 Helpful votes

Resolved! WLC Syslogging

I have a syslog question. We do not send any logs from our controllers to any other system. What is the best software to capture logging from the controllers. We have ciscoworks but we do not have our controllers added to ciscoworks. I am a little bu...

We are forced to rush a installation of a WLC 5508 various reasons in a testing lab. I eventually want to configure RADIUS and such but cannot do it at this immediate time. What I would like to do is impliment straight forward MAC filtering. The prob...

ScottB2113 by Community Member
  • 2935 Views
  • 8 replies
  • 0 Helpful votes

Hi all,the data sheets provide the number of max supported APs on different controller  platforms.However in practise typically services can get affected before reaching this threshold.for obvious reasons no vendor will come out and state the practic...

When adding a new MAC filter on WLC .there are some fields i dont fully understand.1. Profile Name2. Interface Name  3. IP addressif i understand correctly to add MAC filtering to specific WLAN , i need to enable thatin the WLANs security tab.so wher...

Good morning! About this topic I would like to have some clarifications: in a wireless controller  the default is WMM for the AP managed. So what does it mean that? Could APs use a minimum and a maxim time wait of transmission? As explained in the li...

ASF_SVI_ITE by Community Member
  • 2994 Views
  • 3 replies
  • 0 Helpful votes

I have an Aironet 1040 access device, no controller. I have an LDAP server with radius in front to allow for username and password authentication(using MS CHAPv2) with mandatory WEP and PEAP.I was wondering what the strongest security option is that ...

Review Cisco Networking for a $25 gift card