Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
hi! I'm using 55xx wlc. I've one interface/ssid created with wpa ase/tkip + psk. recently we turned off the proxy dhcp settings, and i noticed that the client have issue connecting to that ssid. Fr the laptop you've to open up the wireless connection...
Hi,I`d like to know if that antenna AIR-ANT24120 works with the LAP 1252 in a Mesh deploy.Thanks for your advices,
I need to confirm or deny some conflicting documentation. Cisco states that the 4400/5500 series controllers can support 71 anchor connections. however i have read documentation that a Single anchor controller can support up 40 Ether IP tunnels at ...
I'm trying to setup the wap200 to repeat the wifi signal from the rv-120w signal. On the router the wifi (SSID: stonesoup)has no encryption(intentional), access point isolation is off, SSID broadcast enabled, and is set to VLAN:50. I'm unsure of pr...
Hello!! Fisrt of all, sorry for my english.....I have a problem.....I installed the Cisco Location Services Plug-in for Eclipse so after installation appeared jar files to eclipse\plugins\cisco.locationapi\liband in the Tomcat folder appeared the Loc...
Does anyone know of a deign guide for getting the Braford Network Manager working on a Cisco 5508 controller.
Hi,I've had to downgrade my WLC software from 7.x to 6.x to resolve some issue. I just went ahead and did the downgrade without re-aplying and configs or anything. My setup is very simple, no clean air or advanced features, so is this all OK or shoul...
Resolved! Multiple SSID channel question
I have 2 (for now) Aironet 1231g access points setup. They each have two SSIDs being broadcast on each one, both are the same two SSIDs. The question is, can can two different ssids from a single ap broadcast on the same channel. That means I would h...
I have 3 remote controllers that I need to anchor to a guest wireless controller in a DMZ. Each of the 3 remote controllers has it's own unique mobility domain and unique mobility group.Can these 3 remotes share a common guest anchor (for the guest ...
Resolved! WLC-2504 MAC Filters
If I add a list of MAC addresses to a 2504 to the MAC filter first does it do anything until I actually turn onMAC Filtering in WLAN -> Edit - Security - Layer 2 - MAC Filtering?I'd like to add a list of MAC's to a remote site first then when I'm ons...
Hi,I have a Air Cap 3502i access point. Is it possible to convert this to the standalone mode?thanks,fab
I noticed that a few of our APs have up times of less than 48 hours. A little digging (asking the ethernet switch administrator) and I discovered the PoE switchport on the 4506 switch is set to auto negotiate for speed and duplex, however I did see ...
Hi,I'm using a WLC 2106 running 7.0.116 with EAP-PEAP / Microsft IAS - system worked fine with Autmonomous access points (i.e, RF enviromment / RADIUS etc.), however with the WLC I get requests for usernames and password periodically on iOS devics.Th...
Hello,If I want to register my users and providing connectivity Wireless through my Active Directory is necessary to use a Cisco ACS?Regards,
Hi,I'm looking for help on the syntax to configure option 60 and 43 on a Cisco Router DHCP pool for Option 60 and 43 so that an aruba Networks AP "ArubaAP" can discover it's master controller? Please any help?
