Wireless

Scenario: Latop clients want to make calls on wireless medium and QOS is enabled (WMM), how many voice call can take place simultaneously if some users sending data as well. What is the limit of successful voice calls without any problem in audio qua...

Hi Folks,This evening I tried mocking up a design to create a VPN across our Corporate Network from the Outside Interface of a Cisco ASA 5505 (Remote Site) to the Inside Interface of an ASA 5510 (Local Site).However because I was trying to communicat...

We have just had a Mesh designed by an external company, and when we plugged it in we began have large numbers of mac-flap notification and more than 700mb of traffic sent across our data network.Our setup includes 2 5508 controllers and 9 152x APs3 ...

I am getting alerts on a daily basis for a rogue that is impersonating a valid access point, AP 'xxx' is being contained. This is due to rogue device  spoofing or targeting AP 'xxx' BSSID on '802.11b/g' radio.Can anyone advise on if it's a false alar...

The environment:20 X air-ap1141N-A-K9 (these are standalone) in three different buildings with either 1 or 2 units per floor depending on sq. footage. IOS is c1140-k9w7-tar.124-25d.JA1.ProblemUsers running various tpyes of wireless cards on windows X...

Hi,yesterday I asked if dipole antennas can be used on the 1262 stand alone APs. The answer is yes but, I was wondering specifically, if the 2.4 AIR-ANT2422DW-R=  and the 5.8 AIR-ANT5135DW-R= are compatible with the 1262 AP?Thank you, Pat.

hi Experts,just a question regarding ACL configuration on the WLC. I am a bit confused on when to use CPU ACL and when should we apply the ACL on an interface?it seems CPU ACL is used to filter traffic processed by CPU, so normally used to prevent ac...

Hello,I'm doing some throughput calculation test between a wireless client and a wired desktop computer, and I'm a bit confused about the result i've got. According to the client's card and the WLC, the client is connected to 802.11g, at a speed of 5...

I just upgraded form a WRT 150N to an E4200 router. The main computer, a pc is attached to it with a wire. The other computers are wireless and laptops. The main computer runs windows 7. One laptop runs XP and the other vista. After the installation ...

Client has multiple 1240AG's setup as access points throughout their factory.  They have a PC that they want to connect to the SSID and then be able to get to the Internet as well as the internal network.  The PC has no problem connecting to the SSID...

Hi I have 2 x Redundant Guest Anchor Controllers (5508) located in 2 separate Data Centres with all the management and guest user VLAN spanned between two. Everything is working fine with the Guest WiFi access except the DHCP functionality as the Con...

Hi,I have three questions about the 1260 APS. Can they run autonomously? Can I have them by PoE from the PoE ports on a  asa5505?Can I use 3, 2.4 dipole antennas and 3, 5.8 dipole antennas instead of the other external antennas that attach with the c...

     Hello, i have a WLC, software version 7.0.116. I want to limit bandwidth to one vlan. For what i know i can edit a QOS profile and apply it to a vlan.The thing is that if i try to edit any of the 4 qos profile vlans, platinum, gold, silver and b...