Wireless

Hello,I have an environment in which two WLC 4400 are connected to an anchor WLC 4400 in DMZ, This WLC in DMZ pass the Guest Wlan to other two WLC and terminate tunnel CAPWAP. The Ap in the remote sites, that are configure to register to WLCs in the ...

We currently have WLC's and 1131 LWAP's.  If a client is in one area (no roaming) and we carry out a constant ping, every minute a packet will either be dropped or have a huge response time (2000ms ish).This happens when using EAP-FAST.  If I configu...

Hello,I'm having Roaming-Problems with 7925 Wireless Phones. The 7925 in some cases lose their connection during Layer 3 Roaming to another controller.My Setup:- 7921 Wireless Phones- 2 WiSMs (4 4402 Controllers)- WCS- 1142 Access-Points- 1 Mobility ...

Hi all !I have 2 module ISDM-2 version 7.0.2E4. Use IDM load configuration fail " Rdep thread timeout ". I upgrade but can not. When i load images from FTP server ok. But i wait long time, no extrat file upgrade. CPU 1 & 2 alway 100%.Help Me. my engl...

Greetings one and all, was browsing the net trying to get some answers and was wondering if anyone could be of assistance.we recently bought a  4402  WLAN controller and for the most everything is workig the way it should, however we now have the nee...

Hi,I am trying to configure a Windows XP service pack 3 wireless client for PEAP authentication to a Cisco 1242 and I cannot have my Client talking to the AP. Always have the following degut ouput:dot11_auth_parse_client_pak: Received EAPOL packet fr...

We have the WiSM in a 6509 and I found this alarm in the WCS. Controller '<IP Address Controller 2>'. Data path on anchor '<IP Address Controller 1>' is down.I rebooted each controller and all seemed to come back up okay but I am trying to understand...

How do I program an ASA5510 running 8.2(2) and using ADSM version 6.2(5) to reject traffic that contains source routing symbols (i.e. mailer RCPT commands.  Thanks for your help in advance.

HelloA client asked me to config different instances in dhcp.He gave me the following config:option 43 instance 3 ip 10.5.0.1option 43 instance 4 hex 5060option 43 instance 5 hex 5060option 43 instance 7 hex 06option 43 instance 8 hex 05option 43 ins...

Hi All,This seems to have happened after upgrading to v7: I've a test guest SSID that my test client PC cannot connect to as it seems to immediately try to associate with the corporate secure SSID. The foreign controller debug showed a line that said...