Wireless

Good morning,  I am trying to measure the actual output power from a pair of Aironet 1310G's.  They are both set to 1mW and 1MBPS, the antenna ports are connected by cables measured to 1.5 dB of loss to a channel emulator with a built in power meter....

I have 1 controller the way I want it configured and my second controller not the way I want it.  I want my Cisco Wireles Control Server to take the config from controlelr 1 and make it the template. Then I want to send down my template to update con...

All - Hypothetical scenario:Three branch offices each with their own 5508 controller and a local spare for backup.  Each has their own VLANs and routing between offices over an MPLS network.  For simple math, each of the three controllers has a max o...

My client bought 10 AIR-LAP1522AGs and a 4402 controller.  They want to use them in pairs to establish 5 x wireless bridges.  I have configied the controller and have added all the APs into the controller as either RAPs or MAPs.I cannot figure out ho...

Hello Experts,I've 6 Aironet AP configured with 3 ssid's and mapped to specifice vlan's My question do I have configured different channel on each access points or keep the defaul settings.? please clarifythanking in advance for clarification.Samir

Hi,I have been deploying a new wireless network using 5508 WLC (running 7.0.98) and 3502 APs.I followed the configuration guide found on:http://www.cisco.com/en/US/customer/products/ps6366/products_tech_note09186a0080a3443f.shtmlWhen I try to chek my...

Hello,im searching for an option to make a Report on the WCS (Software Version 6.0.170.0 )  to see all SSIDs that are ratiated in detail by the Access Points.I mean something like this: (example)AP 1   -  SSID 1 and SSID 2AP2   -   SSID 1AP3   -   SS...

I have a small wireless network of one wlc 4402 and 10 little access points This morning, after a thunderstorm raining a   whole nigh, only 9 of them is visible on my wlc.I've tried to reset the one that is missing but with no success - it didn't ap...

Is it possible to import new (IEEE) vendor code list to get correct information regarding clients MAC-addresses? There are too many client vendor codes reported as "Unknown" lately......Running 6.0.196.0./jonas

I bougth cisco Aironet 1250 series few days ago, after configuration window 7 clients were able to (Associate) access interrnet through it but window XP clients didn't access internet(associate) through it, after all troubleshooting i decided upgrade...

Hi All,i have to setup WCS Enterprise on several servers with a 1000 AP License and a Secondary Server "in the Middle". Can anybody help me with Informations regarding Licensing, how to setup the Secondary Server, in which step of the Installation do...