Wireless

Hi all,How does the Antenna gain value (in .5 dBm units) in WLC affects the transmit power of the AP?Consider that we have configured the power level of the AP to "1" which is the maximum and we have no gain value.If we change the gain value to one t...

hi ,We have a WCS : /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Tableau Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padd...

I am getting this error on several AP's and then the interface is shutdown for 60 seconds.How do I determine what is causing these errors?The errors are generated by many MAC addresses.

I'd thought this would be an easy thing to sort out from the main Cisco website, but I've had no luck so far. I'm trying to understand the software support requirements for our WCS software.We started a few years ago with a WLC4402-25, WCS 5.0 base o...

I'm trying to figure out why some APs radios quit working when supplied with PoE.Yesterday I moved two converted 1131 LWAPs from one controller on one WiSM to a different controller on a different WiSM in an adjacent chassis.  Now none of the radios ...

Hey,I have a project setup using a 1200 Access Point and a 1200 Workgroup Bridge mobile station, this setup is working great.I want to extend the range by placing a 1200 in repeater mode on the edge of coverage then be able to move the WGB further al...

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin:0cm; mso-para-margin-bo...

I've been using Airmagnet Spectrum Analyzer, it's been giving me some issues. Been looking at Cisco Spectrum Expert and Airmagnet Spectrum Analyzer XT. Just like to know some folks opinions on one or the other. If one may be a little better or have a...

Hi,Does anyone know what I need to mesh the Cisco Aironet 1131 series access points together.  I have a few spread around a small campus and was wondering if this series is even able to be meshed & what components I'd need to make this happen?Thanks,...

Hi, we have an open (Layer 2 security=none) wlan used by vistors to our building. We sometimes get complaints about the wifi disconnecting. I notice on the Advanced tab that the session timeout is enabled and set for 1800 seconds. Is the session time...