Wireless

Hello Friends, We recently installed 2 4402 WLCs. I configured Mobility group and split the APs between 2 WLCs by configuring Primary Controller on each AP. No secondary or tertiary Controller was configured.Now when WLC1 goes down, the APs on WLC1 r...

I have a 1242AP that I believe is in autonomous mode(the controller doesn't see it but the AP can ping the controller) but I can't upgrade the IOS on the AP. I can ping the AP from my laptop but I can't open the GUI. Is it possible to upgrade the IOS...

Hi All,I have just converted my unit of AP1200 to LWAPP by only copy c1200-rcvk9w8-mx into the AP and set AP to boot from this image. After which, I try have the AP associate the WLC. But it fails and keep reooting. Is there anyway to stop the AP fro...

WCS 5.1. I can't find any way to download a sample.tar file from the WCS for a passthrough template, only for a webauth (username+password) template. Is it in there and I'm just blind? Or is there anyplace else I can find a tar bundle template for a ...

HiI am using subject mentioned APs(Fat).I have two distances(almost 40 meter and 90 meter) to be covered.There is no possibility to reach through cables either by Cat or Fiber.Is there is APs mode we can configure Bridge or .. that can cover above me...

Hi,As I can only use 3 channels in 1 cell what happens if I have more than 30 users in this cell? So if I add another access point on say channel 4 it will interfere with channel 1 and channel 6.So what can I do? apart from using 802.11a ? Also at ...

Hi,After replacing D-Link outdoor AP with LAP1522AG (3 AIR-ANT2450V-N type antennas)there is no stable wireless connection at the corner of the house opposite to AP because of the weak signal. AP is connected to 220 V AC. Current Tx Power Level - 1,...

Hi, I'm trying to add my autonomous access points to WCS which I have done but I'm not getting any performance data or errors etc. Does anyone know if WCS support autonomous access points or do I have to use WLSE to get this infoThanks

(This appears to be the converse situation of another relatively recent post. I thought it might be better to have a separate thread rather than muddy up that conversation).I have a relatively new deployment of 8 WiSMs controllers (4 of which are cu...

Hi,What bandwith is possible between one AP 1250 (workgroup-bridge and Access-Point)with the 802.1n standart?regardsPascal

Hi,we use a WLC4402 with LWAPPs and different VLANs and SSIDs. I've configured a Linksys WET200 to associate to one of the SSIDs.On the WLC I can see, that the WET200 is associated. But with the connected PC to the WET200 (static IP) I can't ping any...

How does this work?I enabled HREAP to make wifi phones get the same network IP as the regualar Desk phone. But...the IP does not change if there is a overlap signal.

Hi, How I can to recovery password in the Wireless Control System version 4.2 (Windows Server) ?

Running into an issue where multiple users have complained that their 7921 phones have flipped to vibrate without their involvement.I realize holding the asterisks key can engage vibrate - thinking that could be hit by accident in a pocket or somethi...

Is SSH on TCP port 22 use from the client perspective to access the wireless network or for other type of communication between the client and the AP ?? Thank youVic